RE: [PATCH net v5 5/5] net: qualcomm: rmnet: Resize endpoints with dev_set_mtu() and restore on failure
From: subash.a.kasiviswanathan
Date: Sat Nov 21 2026 - 10:51:17 EST
> -----Original Message-----
> From: netdev-bot+sashiko@xxxxxxxxxx <netdev-bot+sashiko@xxxxxxxxxx>
> Sent: Saturday, November 21, 2026 12:04 AM
> To: subash.a.kasiviswanathan@xxxxxxxxxxxxxxxx
> Cc: sean.tranchetti@xxxxxxxxxxxxxxxx; andrew+netdev@xxxxxxx;
> davem@xxxxxxxxxxxxx; edumazet@xxxxxxxxxx; kuba@xxxxxxxxxx;
> pabeni@xxxxxxxxxx; netdev@xxxxxxxxxxxxxxx; linux-kernel@xxxxxxxxxxxxxxx
> Subject: Re: [PATCH net v5 5/5] net: qualcomm: rmnet: Resize endpoints with
> dev_set_mtu() and restore on failure
>
> Thank you for your contribution! Sashiko AI review found 2 potential
> issue(s) to consider.
>
> Critical: 0 · High: 0 · Medium: 1 · Low: 1
>
> If you believe none of the issues are legitimate, please reply to each
> issue of Medium severity or higher and explain why the AI is wrong.
> If any of them are legitimate and you plan to respin, please let patchwork
> know by including "pw-bot: cr" as a separate line at the end of your reply
> (one such reply per series is enough).
>
> - [Medium] rmnet_vnd_update_dev_mtu()
> (drivers/net/ethernet/qualcomm/rmnet/rmnet_vnd.c:447-473) now
> shrinks…
> - [Low] The commit message opens with "When the real device MTU or the
> data format requires a smaller MTU, existing endpoints are shrunk by…
>
> --
>
> net: qualcomm: rmnet: Resize endpoints with dev_set_mtu() and restore on
> failure
>
> This commit changes rmnet_vnd_update_dev_mtu() so it shrinks existing
> endpoints with dev_set_mtu() instead of calling the ndo directly. As a
> result, MTU notifiers and link notifications are now delivered. If resizing
> an endpoint fails, the endpoints already resized are put back to their
> saved MTU, and the original error is returned.
>
> > When the real device MTU or the data format requires a smaller MTU,
> > existing endpoints are shrunk by writing dev->mtu directly. No MTU
> > notifiers run and userspace gets no link notification.
>
> [Severity: Low]
> Is the part about the real device MTU accurate?
>
> rmnet_vnd_update_dev_mtu() has only two callers, rmnet_newlink() and
> rmnet_changelink(). The changelink call only happens when
> IFLA_RMNET_FLAGS
> is present, which means a data format change.
>
> When the real device MTU changes, rmnet_config_notify_cb() only validates
> the new value and vetoes it if needed:
>
> drivers/net/ethernet/qualcomm/rmnet/rmnet_config.c:rmnet_config_notify_
> cb() {
> ...
> case NETDEV_CHANGEMTU:
> if (rmnet_vnd_validate_real_dev_mtu(real_dev))
> return NOTIFY_BAD;
> ...
> }
>
> So endpoints are never shrunk on that path, either before or after this
> patch.
>
> Could the commit message be limited to the data format case? As written,
> it suggests this fix also covers the real device MTU path.
>
> > diff --git a/drivers/net/ethernet/qualcomm/rmnet/rmnet_vnd.c
> b/drivers/net/ethernet/qualcomm/rmnet/rmnet_vnd.c
> > index 8bf87c5ecb43b..dce436e4c6305 100644
> > --- a/drivers/net/ethernet/qualcomm/rmnet/rmnet_vnd.c
> > +++ b/drivers/net/ethernet/qualcomm/rmnet/rmnet_vnd.c
> > @@ -433,24 +433,42 @@ int rmnet_vnd_validate_real_dev_mtu(struct
> net_device *real_dev)
>
> [ ... ]
>
> > hash_for_each_safe(port->muxed_ep, bkt_ep, tmp_ep, ep, hlnode) {
> > - if (ep->egress_dev->mtu <= new_mtu)
> > + ep->saved_mtu = ep->egress_dev->mtu;
> > + if (ep->saved_mtu <= new_mtu)
> > continue;
> >
> > - err = rmnet_vnd_change_mtu(ep->egress_dev, new_mtu);
> > - if (err)
> > - return err;
> > + err = dev_set_mtu(ep->egress_dev, new_mtu);
> > + if (err) {
> > + fail_ep = ep;
> > + break;
> > + }
> > }
> >
> > - return 0;
> > + if (!err)
> > + return 0;
> > +
> > + /* Restore the endpoints which were already resized. Failures here
> > + * are ignored since the original error is the one to report.
> > + */
> > + hash_for_each_safe(port->muxed_ep, bkt_ep, tmp_ep, ep, hlnode) {
> > + if (ep == fail_ep)
> > + break;
> > +
> > + if (ep->egress_dev->mtu != ep->saved_mtu)
> > + dev_set_mtu(ep->egress_dev, ep->saved_mtu);
>
> [Severity: Medium]
> Does this restore undo everything the earlier dev_set_mtu() calls did?
>
> Now that the shrink goes through dev_set_mtu(), netif_set_mtu_ext() runs
> the NETDEV_PRECHANGEMTU and NETDEV_CHANGEMTU notifier chains for
> each
> endpoint.
>
> A PRECHANGEMTU notifier can now veto the shrink. For example,
> team_device_event() does this:
>
> drivers/net/team/team_core.c:team_device_event() {
> ...
> case NETDEV_PRECHANGEMTU:
> /* Forbid to change mtu of underlaying device */
> if (!port->team->port_mtu_change_allowed)
> return NOTIFY_BAD;
> ...
> }
>
> Before this patch, the direct rmnet_vnd_change_mtu() call could not fail
> here, because new_mtu < ep mtu <= real_dev->mtu - old headroom. So a
> newlink or changelink with IFLA_RMNET_FLAGS that used to succeed can now
> return an error.
>
> If the veto happens on a later endpoint, the CHANGEMTU notifiers have
> already run on the earlier ones. If the temporary new_mtu was below
> IPV6_MIN_MTU, addrconf_notify() tore down IPv6 on those endpoints:
>
> net/ipv6/addrconf.c:addrconf_notify() {
> ...
> case NETDEV_CHANGEMTU:
> /* if MTU under IPV6_MIN_MTU stop IPv6 on this interface.
> */
> if (dev->mtu < IPV6_MIN_MTU) {
> addrconf_ifdown(dev, dev != net->loopback_dev);
> break;
> }
> ...
> }
>
> In the same way, inetdev_event() falls through to inetdev_destroy() when
> the MTU is below the IPv4 minimum.
>
> Restoring saved_mtu only creates a new, empty inet6_dev or in_device. The
> configured addresses, routes and per-device sysctls are still lost, even
> though the request returned an error.
>
> For example, take a real_dev MTU of 1284 with no checksum offload (4 bytes
> of headroom). Endpoint A has a lower mux_id, has IPv6 configured and is at
> 1280. Endpoint B has a higher mux_id, is a team port and is also at 1280. A
> changelink that sets CKSUMV5 (8 bytes of headroom) gives new_mtu = 1276:
>
> dev_set_mtu(A, 1276) -> addrconf_ifdown(A, true)
> dev_set_mtu(B, 1276) -> vetoed by team_device_event(), -EPERM
> dev_set_mtu(A, 1280) -> A comes back with no IPv6 addresses
>
> Userspace also gets a shrink-then-grow pair of RTM_NEWLINK events for A,
> for a request that failed.
>
> The commit message says a failed request "does not leave some of them
> shrunk". That holds for the MTU values but not for the L3 state.
>
> Is this partial rollback intended? If so, should the commit message
> mention the new veto failures and the lost L3 state on endpoints that were
> already resized?
>
> > + }
> > +
> > + return err;
> > }
>
Yes, partial rollback is expected here. The comment above the rollback logic already mentions that - "Failures here
are ignored".