[...usual stuff...]
ide: buggy CMD640B interface on pci (0x80001000); serialized, secondary port untouched
hda: WDC AC31000F, 1033MB w/64kB Cache, LBA, CHS=525/64/63
Drive Timing: PIO Mode 3 (180ns) w/IORDY (overriding vendor mode), Read-ahead: enabled
hdb: WDC AC2420F, 405MB w/64kB Cache, CHS=989/15/56
[and here it stops instead of displaying the cdrom, hdb's timing, etc..]
Cheers,
Jochen Toppe
jtoppe@cs.uah.edu
P.S. I am all for creating a modified number scheme, for example
the 2.0.10b[123...] seemed a very good idea. I mean, obviously
there was a major (?) change in the CMD640 code which apparently
introduced bad side effects and that would be nice to be tested
out first, right? Afterall this kernel is supposed to be stable.
[Does that include booting? *laughs*]
P.P.S. No hardware failure. Runs fine under 2.0.0 as I type.
My configuration [2.0.10]:
#
# Automatically generated make config: don't edit
#
#
# Code maturity level options
#
CONFIG_EXPERIMENTAL=y
#
# Loadable module support
#
CONFIG_MODULES=y
# CONFIG_MODVERSIONS is not set
CONFIG_KERNELD=y
#
# General setup
#
# CONFIG_MATH_EMULATION is not set
CONFIG_NET=y
# CONFIG_MAX_16M is not set
CONFIG_PCI=y
CONFIG_PCI_OPTIMIZE=y
CONFIG_SYSVIPC=y
CONFIG_BINFMT_AOUT=y
CONFIG_BINFMT_ELF=y
CONFIG_BINFMT_JAVA=y
CONFIG_KERNEL_ELF=y
# CONFIG_M386 is not set
# CONFIG_M486 is not set
CONFIG_M586=y
# CONFIG_M686 is not set
#
# Floppy, IDE, and other block devices
#
CONFIG_BLK_DEV_FD=y
CONFIG_BLK_DEV_IDE=y
#
# Please see Documentation/ide.txt for help/info on IDE drives
#
# CONFIG_BLK_DEV_HD_IDE is not set
CONFIG_BLK_DEV_IDECD=y
# CONFIG_BLK_DEV_IDETAPE is not set
# CONFIG_BLK_DEV_IDE_PCMCIA is not set
CONFIG_BLK_DEV_CMD640=y
# CONFIG_BLK_DEV_RZ1000 is not set
# CONFIG_BLK_DEV_TRITON is not set
# CONFIG_IDE_CHIPSETS is not set
#
# Additional Block Devices
#
CONFIG_BLK_DEV_LOOP=y
# CONFIG_BLK_DEV_MD is not set
# CONFIG_BLK_DEV_RAM is not set
# CONFIG_BLK_DEV_XD is not set
# CONFIG_BLK_DEV_HD is not set
#
# Networking options
#
# CONFIG_FIREWALL is not set
# CONFIG_NET_ALIAS is not set
CONFIG_INET=y
# CONFIG_IP_FORWARD is not set
# CONFIG_IP_MULTICAST is not set
# CONFIG_IP_ACCT is not set
#
# (it is safe to leave these untouched)
#
# CONFIG_INET_PCTCP is not set
# CONFIG_INET_RARP is not set
# CONFIG_NO_PATH_MTU_DISCOVERY is not set
CONFIG_IP_NOSR=y
CONFIG_SKB_LARGE=y
#
#
#
CONFIG_IPX=y
# CONFIG_IPX_INTERN is not set
# CONFIG_ATALK is not set
# CONFIG_AX25 is not set
# CONFIG_BRIDGE is not set
# CONFIG_NETLINK is not set
#
# SCSI support
#
CONFIG_SCSI=y
#
# SCSI support type (disk, tape, CD-ROM)
#
CONFIG_BLK_DEV_SD=y
# CONFIG_CHR_DEV_ST is not set
CONFIG_BLK_DEV_SR=y
CONFIG_CHR_DEV_SG=y
#
# Some SCSI devices (e.g. CD jukebox) support multiple LUNs
#
# CONFIG_SCSI_MULTI_LUN is not set
# CONFIG_SCSI_CONSTANTS is not set
#
# SCSI low-level drivers
#
# CONFIG_SCSI_7000FASST is not set
# CONFIG_SCSI_AHA152X is not set
# CONFIG_SCSI_AHA1542 is not set
# CONFIG_SCSI_AHA1740 is not set
# CONFIG_SCSI_AIC7XXX is not set
# CONFIG_SCSI_ADVANSYS is not set
# CONFIG_SCSI_IN2000 is not set
CONFIG_SCSI_AM53C974=y
# CONFIG_SCSI_BUSLOGIC is not set
# CONFIG_SCSI_DTC3280 is not set
# CONFIG_SCSI_EATA is not set
# CONFIG_SCSI_EATA_DMA is not set
# CONFIG_SCSI_EATA_PIO is not set
# CONFIG_SCSI_FUTURE_DOMAIN is not set
# CONFIG_SCSI_GENERIC_NCR5380 is not set
# CONFIG_SCSI_NCR53C406A is not set
# CONFIG_SCSI_NCR53C7xx is not set
# CONFIG_SCSI_NCR53C8XX is not set
# CONFIG_SCSI_PPA is not set
# CONFIG_SCSI_PAS16 is not set
# CONFIG_SCSI_QLOGIC_FAS is not set
# CONFIG_SCSI_QLOGIC_ISP is not set
# CONFIG_SCSI_SEAGATE is not set
# CONFIG_SCSI_T128 is not set
# CONFIG_SCSI_U14_34F is not set
# CONFIG_SCSI_ULTRASTOR is not set
#
# Network device support
#
CONFIG_NETDEVICES=y
CONFIG_DUMMY=y
# CONFIG_EQUALIZER is not set
# CONFIG_DLCI is not set
# CONFIG_PLIP is not set
CONFIG_PPP=y
#
# CCP compressors for PPP are only built as modules.
#
# CONFIG_SLIP is not set
# CONFIG_NET_RADIO is not set
CONFIG_NET_ETHERNET=y
# CONFIG_NET_VENDOR_3COM is not set
# CONFIG_LANCE is not set
CONFIG_NET_VENDOR_SMC=y
CONFIG_WD80x3=y
# CONFIG_ULTRA is not set
# CONFIG_SMC9194 is not set
# CONFIG_NET_ISA is not set
# CONFIG_NET_EISA is not set
# CONFIG_NET_POCKET is not set
# CONFIG_TR is not set
# CONFIG_ARCNET is not set
#
# ISDN subsystem
#
# CONFIG_ISDN is not set
#
# CD-ROM drivers (not for SCSI or IDE/ATAPI drives)
#
# CONFIG_CD_NO_IDESCSI is not set
#
# Filesystems
#
# CONFIG_QUOTA is not set
# CONFIG_LOCK_MANDATORY is not set
CONFIG_MINIX_FS=y
# CONFIG_EXT_FS is not set
CONFIG_EXT2_FS=y
# CONFIG_XIA_FS is not set
CONFIG_FAT_FS=y
CONFIG_MSDOS_FS=y
CONFIG_VFAT_FS=y
# CONFIG_UMSDOS_FS is not set
CONFIG_PROC_FS=y
CONFIG_NFS_FS=y
# CONFIG_ROOT_NFS is not set
# CONFIG_SMB_FS is not set
# CONFIG_NCP_FS is not set
CONFIG_ISO9660_FS=y
# CONFIG_HPFS_FS is not set
# CONFIG_SYSV_FS is not set
# CONFIG_AFFS_FS is not set
# CONFIG_UFS_FS is not set
#
# Character devices
#
CONFIG_SERIAL=y
# CONFIG_DIGI is not set
# CONFIG_CYCLADES is not set
# CONFIG_STALDRV is not set
# CONFIG_RISCOM8 is not set
CONFIG_PRINTER=y
# CONFIG_MOUSE is not set
# CONFIG_UMISC is not set
# CONFIG_QIC02_TAPE is not set
CONFIG_FTAPE=m
#
# Set IObase/IRQ/DMA for ftape in ./drivers/char/ftape/Makefile
#
# CONFIG_APM is not set
# CONFIG_WATCHDOG is not set
# CONFIG_RTC is not set
#
# Sound
#
CONFIG_SOUND=y
# CONFIG_LOWLEVEL_SOUND is not set
#
# Kernel hacking
#
# CONFIG_PROFILE is not set