Re: plip module configuration

Ervin D. Walter (edwalter@ewok.not.for.mail)
Fri, 2 Aug 1996 23:40:23 -0500

Ervin D. Walter writes:
> Is is possible to configure the plip.o module on the insmod command line
> to only "take over" specified parallel ports in a manner similar to
> lp.o configuration. For example:
>
> insmod lp.o io=0x378 irq=7
>

I guess I should have read the plip code more carefully before I
asked. 5 minutes after I sent this email, I found the same code in
plip.c that is in lp.c to configure plip. Just so others don't make
the same mistake, you can configure plip with the exact same
parameters as lp shown above...

Sorry to waste the bandwidth,
Erv

-- 
                                  ,,,
                                 (o o)
-----------------------------oOOo-(_)-oOOo-----------------------------
Different all twisty a of in                         - edwalter@usa.net
maze are you, passages little.                   - edwalter@sprynet.com


PGP Key fingerprint =  A5 AB 25 7D 7A FD 4D FE  BE 21 47 60 0C DC 67 9E