tar cvlf /dev/rst0 /home
on first big file I got...
tar: can't write to /dev/rst0 : I/O error
in log...
Aug 21 14:34:15 zeus kernel: st0: Error with sense data: extra data not
valid Current error st09:00: sns = 70 3
Aug 21 14:34:15 zeus kernel: ASC= c ASCQ= 0
Aug 21 14:34:15 zeus kernel: Raw sense data:0x70 0x00 0x03 0x00 0x00 0x00
0x00 0x0a 0x00 0x00 0x00 0x00 0x0c 0x00 0x00 0x00
Aug 21 14:34:15 zeus kernel: st0: Error with sense data: extra data not
valid Current error st09:00: sns = 70 3
Aug 21 14:34:15 zeus kernel: ASC= c ASCQ= 0
Aug 21 14:34:15 zeus kernel: Raw sense data:0x70 0x00 0x03 0x00 0x00 0x00
0x00 0x0a 0x00 0x00 0x00 0x00 0x0c 0x00 0x00 0x00
Aug 21 14:34:15 zeus kernel: st0: Error on write filemark.
/proc/scsi...
Attached devices:
Host: scsi0 Channel: 00 Id: 00 Lun: 00
Vendor: CONNER Model: CFP2105S 2.14GB Rev: 2B4B
Type: Direct-Access ANSI SCSI revision: 02
Host: scsi0 Channel: 00 Id: 01 Lun: 00
Vendor: CONNER Model: CFP2105S 2.14GB Rev: 2B4B
Type: Direct-Access ANSI SCSI revision: 02
Host: scsi0 Channel: 00 Id: 02 Lun: 00
Vendor: TOSHIBA Model: CD-ROM XM-3601TA Rev: 0725
Type: CD-ROM ANSI SCSI revision: 02
Host: scsi0 Channel: 00 Id: 04 Lun: 00
Vendor: EXABYTE Model: EXB-4200c Rev: 217
Type: Sequential-Access ANSI SCSI revision: 02
..../aic7xxx/0...
Adaptec AIC7xxx driver version: 3.4/3.2/3.1
Compile Options:
AIC7XXX_RESET_DELAY : 5
AIC7XXX_TWIN_SUPPORT : Enabled
AIC7XXX_TAGGED_QUEUEING: Enabled
AIC7XXX_PAGE_ENABLE : Enabled
AIC7XXX_PROC_STATS : Disabled
Adapter Configuration:
SCSI Adapter: AHA-2940
(AIC-787x chipset)
Host Bus: Single
Base IO: 0xfc00
IRQ: 11
SCBs: Used 17, HW 16, Page 255
Interrupts: 339028
Serial EEPROM: True
Extended Translation: Enabled
SCSI Bus Reset: Enabled
Ultra SCSI: Disabled
Target Disconnect: Enabled
BTW when I boot the system now, all lights on the DAT glow - this is new
behaviour.
___ | info@cygnet.co.uk
| ___ ___ ___ _/_ Your | http://www.cygnet.co.uk
| \ / | | / / /__/ / Professional | Tel: 0181 880 4650
|___ \/ |__|/ / /__ /__ Connection | Fax: 0181 880 4651
/ ___|