ide problem with 2.1.84

Robbie Murray (robbie@scot-mur.demon.co.uk)
Wed, 4 Feb 1998 17:19:08 +0000 (GMT)


When booting 2.1.84, I get the following messages(I have only tried
2.1.84, 2.0.33 works ok.

PCI_IDE Unknown IDE controller on PCI bus 0 function 145, VID=1060,
DID=673a

PCI_IDE not 100% native mode: will probe irqs later.
hda: probing with STATUS(0x50) instead of ALTSTATUS(0xff)
hda: Maxtor 71084 A, ATA DISK drive
hdb: FX001DE, ATAPI CDROM drive
hdc: ST31722A, ATA DISK drive
ide2: ports already in use, skipping probe
ide0: at 0x1f0-0x1f7,0x3f6 on irq 14
ide1: at 0x170-0x177,0x376 on irq 15
ne.c:v1.10 9/23/94 Donald Becker (becker@cesotis.gsfc.nasa.gov)
NE*000 ethercard probe at 0x300: 00 00 01 13 45 09
eth0: NE2000 found at 0x300, using IRQ 12
Partition check:
hda: driver not present
VFS: Cannot open root device 03:01
Kernel panic: VFS: Unable to mount root fs on 03:01

I'm not sure if its got something to do with my sound card. The ide port
is disabled in the dos config program, but appart from that I only have 2
ide controlers. Here are the relivant parts from the 2.0.33 boot messages.

pcibios_init : BIOS32 Service Directory structure at 0x000f6f10
pcibios_init : BIOS32 Service Directory entry at 0xf6f20
pcibios_init : PCI BIOS revision 2.10 entry at 0xf6f41
...
hda: probing with STATUS instead of ALTSTATUS
hda: Maxtor 71084 A, 1036MB w/64kB Cache, CHS=526/64/63
hdb: FX001DE, ATAPI CDROM drive
hdc: ST31722A, 1625MB w/128kB Cache, CHS=3303/16/63
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
ne.c:v1.10 9/23/94 Donald Becker (becker@cesdis.gsfc.nasa.gov)
NE*000 ethercard probe at 0x300: 00 00 01 13 45 09
eth0: NE2000 found at 0x300, using IRQ 12.
Partition check:
hda: hda1 hda2 hda3 hda4
hdc: hdc1
VFS: Mounted root (ext2 filesystem) readonly.

Thanks.

Regards

Rob

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu