I just installed 2.1.86. I have an internal zip drive with a zoom board
that uses the aha15x low level driver. I want to be able to load it as a
module, and I am sure I have put the correct parameters in
/etc/conf.modules. Here's what happens when I try to load the scsi mods.
[root@localhost scsi]# modprobe scsi_mod
[root@localhost scsi]# modprobe sd_mod
[root@localhost scsi]# modprobe aha152x
aha152x: BIOS test: passed, detected 1 controller(s)
aha152x0: vital data: PORTBASE=0x340, IRQ=11, SCSI ID=5,
reconnect=enabled, parity=enabled, synchronous=disabled, delay=100,
extended translation=disabled
aha152x: trying software interrupt, lost.
aha152x: IRQ 11 possibly wrong. Please verify.
scsi1 : Adaptec 152x SCSI driver; $Revision: 1.7 $
scsi : 1 host.
I am confident that I have the zoom board in the IRQ 11 setting, and
windows NT runs it through IRQ 11.
So... is this a bug, or is there something I'm doing wrong?
BTW, I had the same problem in 2.1.85.
Wes M
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu