Everything works okay, but this was very disconcerting when I was having
trouble getting the kernel to boot.
Thanks
Jeff
--Configuring Adaptec (SCSI-ID 7) at IO:330, IRQ 14, DMA priority 5 aic7xxx: <Adaptec AHA-394X SCSI host adapter> at PCI 4 aic7xxx: BIOS enabled, IO Port 0x2000, IO Mem 0xc4000000, IRQ 15, Revision B aic7xxx: Wide Channel A, SCSI ID 7, 16/255 SCBs, QFull 16, QMask 0x1f aic7xxx: <Adaptec AHA-394X SCSI host adapter> at PCI 5 aic7xxx: BIOS enabled, IO Port 0x2400, IO Mem 0xc4010000, IRQ 9, Revision B aic7xxx: Wide Channel B, SCSI ID 7, 16/255 SCBs, QFull 16, QMask 0x1f scsi0 : Adaptec 1542 scsi1 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 4.1/3.2 scsi2 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 4.1/3.2 scsi : 3 hosts. Vendor: HP Model: C3323-300 Rev: 4269 Type: Direct-Access ANSI SCSI revision: 02 Detected scsi disk sda at scsi0, channel 0, id 0, lun 0 Vendor: EXABYTE Model: EXB-8200 Rev: 2618 Type: Sequential-Access ANSI SCSI revision: 01 Detected scsi tape st0 at scsi0, channel 0, id 2, lun 0 scsi1: Scanning channel A for devices. scsi1: Sending SDTR!! Vendor: IBMRISC Model: DFHSS2W Rev: 4242 Type: Direct-Access ANSI SCSI revision: 02 Detected scsi disk sda at scsi1, channel 0, id 0, lun 0 scsi2: Scanning channel A for devices. scsi2: Sending SDTR!! Vendor: IBMRISC Model: DFHSS2W Rev: 4242 Type: Direct-Access ANSI SCSI revision: 02 Detected scsi disk sda at scsi2, channel 0, id 0, lun 0 scsi : detected 1 SCSI tape 3 SCSI disks total. SCSI device sda: hdwr sector= 512 bytes. Sectors= 2056008 [1003 MB] [1.0 GB] SCSI device sda: hdwr sector= 512 bytes. Sectors= 4404489 [2150 MB] [2.2 GB] SCSI device sda: hdwr sector= 512 bytes. Sectors= 4404489 [2150 MB] [2.2 GB] PPP: version 2.3.3 (demand dialling) TCP compression code copyright 1989 Regents of the University of California PPP line discipline registered. tulip.c:v0.83 10/19/97 becker@cesdis.gsfc.nasa.gov eth0: Digital DS21040 Tulip at 0x3000, 08 00 2b e5 42 4e, IRQ 11. PCI latency timer (CFLT) is unreasonably low at 0. Setting to 64 clocks. Partition check: sda: sda1 sda2 sda3 sdb: sdb1 sdc: sdc1
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu