Just a brief problem report.
Adapter: AHA2940 BIOS v1.23
Machine: IBM PC i586.
Kernel: 2.0.34 is fine.
Kernel: 2.1.105 goes in a loop resetting the adapter.
Here is what 2.0.34 says about my scsi:
aic7xxx: Warning - detected auto-termination on controller:
aic7xxx: <Adaptec AHA-294X Ultra SCSI host adapter> at PCI 6/0
aic7xxx: Please verify driver detected settings are correct.
aic7xxx: If not, then please properly set the device termination
aic7xxx: in the Adaptec SCSI BIOS by hitting CTRL-A when prompted
aic7xxx: during machine bootup.
aic7xxx: Cables present (Int-50 YES, Int-68 NO, Ext-68 NO)
aic7xxx: Termination (Low ON, High ON)
(scsi0) <Adaptec AHA-294X Ultra SCSI host adapter> found at PCI 6/0
(scsi0) Wide Channel, SCSI ID=7, 16/255 SCBs
(scsi0) BIOS enabled, IO Port 0x1000, IRQ 14
(scsi0) IO Memory at 0x80000000, MMAP Memory at 0x281b000
(scsi0) Downloading sequencer code... 413 instructions downloaded
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.0.13/3.2.4
<Adaptec AHA-294X Ultra SCSI host adapter>
scsi : 1 host.
(scsi0:0:-1:-1) Scanning channel for devices.
(scsi0:0:0:0) Refusing WIDE negotiation; using 8 bit transfers.
(scsi0:0:0:0) Synchronous at 20.0MHz, offset 15.
Vendor: IBM Model: DORS-32160 !# Rev: WA1A
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
(scsi0:0:5:0) Refusing WIDE negotiation; using 8 bit transfers.
(scsi0:0:5:0) Synchronous at 5.0MHz, offset 15.
Vendor: IBM Model: CDRM00203 !K Rev: BZ26
Type: CD-ROM ANSI SCSI revision: 02
Detected scsi CD-ROM sr0 at scsi0, channel 0, id 5, lun 0
SCSI device sda: hdwr sector= 512 bytes. Sectors= 4226725 [2063 MB] [2.1 GB]
sda: sda1 sda2 sda4
Regards,
------
Tigran A. Aivazian | http://www.sco.com/
Escalations Research Group | Email: tigran@sco.com
Santa Cruz Operation Ltd |
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu