Slava
-- Slava Pestov (mailto:slava_pestov@geocities.com) http://www.geocities.com/SiliconValley/Heights/7925 Linux 2.0.35 on an i586MMX (400.59 BogoMips) > Hello! > > I am having boot problem with 2.1.121 > When I try use LILO (20 from Slackware 3.5) to boot up > linux kernel 2.1.121, I just getting reboot right after > 'Loading linux.......' in 6-8 tries from 10, some times > I getting hungs instead of reboots > One or two times It is complained about 'crc error'. > However if I dd kernel to floppy or try to load it with > LoadLin from DOS, all is fine. I even tried to copy > kernel at another location on ext2fs to ensure that there is > not corrupted disk area. No luck. Kernels since 2.1.85 to > 2.1.120 behaves well, 2.0.X is good too. > If I boot 2.1.121, ten probability of loading next time > before power cycle is increased until I load another kernel. > Am I doing something wrong, or what can it be? > > I use just plain Pentium 166 and mobo with plain Intel VX chipset. > 16M of RAM. All kernels compiled with GCC 2.7.2.3. Here is my /proc/cpuinfo, kernel > config and output of kernel at boot time. > processor : 0 > vendor_id : GenuineIntel > cpu family : 5 > model : 2 > model name : Pentium 75+ > stepping : 12 > fdiv_bug : no > hlt_bug : no > sep_bug : no > f00f_bug : yes > fpu : yes > fpu_exception : yes > cpuid level : 1 > wp : yes > flags : fpu vme de pse tsc msr mce cx8 > bogomips : 66.76 > > Linux version 2.1.121 (root@mordor) (gcc version 2.7.2.3) #7 Fri Sep 11 23:53:48 MSD 1998 > Console: colour VGA+ 80x25 > Calibrating delay loop... 66.76 BogoMIPS > Memory: 14932k/16384k available (644k kernel code, 400k reserved, 376k data, 32k init) > CPU: Intel Pentium 75+ stepping 0c > Checking 386/387 coupling... OK, FPU using exception 16 error reporting. > Checking 'hlt' instruction... OK. > Intel Pentium with F0 0F bug - workaround enabled. > POSIX conformance testing by UNIFIX > PCI: PCI BIOS revision 2.10 entry at 0xfb280 > PCI: Using configuration type 1 > PCI: Probing PCI hardware > Swansea University Computer Society NET3.039 for Linux 2.1 > NET3: Unix domain sockets 0.16 for Linux NET3.038. > Swansea University Computer Society TCP/IP for NET3.037 > IP Protocols: ICMP, UDP, TCP > Starting kswapd v 1.5 > Serial driver version 4.26 with no serial options enabled > ttyS00 at 0x03f8 (irq = 4) is a 16550A > ttyS01 at 0x02f8 (irq = 3) is a 16550A > Real Time Clock Driver v1.09 > PIIX3: IDE controller on PCI bus 00 dev 39 > PIIX3: not 100% native mode: will probe irqs later > ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:pio, hdb:pio > ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:pio, hdd:pio > hda: QUANTUM FIREBALL_TM1280A, ATA DISK drive > hdb: ST31722A, ATA DISK drive > hdd: MATSHITA CR-583, ATAPI CDROM drive > ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 > ide1 at 0x170-0x177,0x376 on irq 15 > hda: QUANTUM FIREBALL_TM1280A, 1222MB w/76kB Cache, CHS=621/64/63, DMA > hdb: ST31722A, 1625MB w/0kB Cache, CHS=825/64/63, DMA > Partition check: > hda: hda1 hda2 < hda5 hda6 > hda3 > hdb: hdb1 hdb2 hdb3 < hdb5 > hdb4 > VFS: Mounted root (ext2 filesystem) readonly. > Freeing unused kernel memory: 32k freed > > CONFIG_EXPERIMENTAL=y > CONFIG_M586=y > CONFIG_MODULES=y > CONFIG_MODVERSIONS=y > CONFIG_KMOD=y > CONFIG_NET=y > CONFIG_PCI=y > CONFIG_PCI_BIOS=y > CONFIG_PCI_DIRECT=y > CONFIG_PCI_QUIRKS=y > CONFIG_PCI_OPTIMIZE=y > CONFIG_PCI_OLD_PROC=y > CONFIG_SYSVIPC=y > CONFIG_SYSCTL=y > CONFIG_BINFMT_AOUT=m > CONFIG_BINFMT_ELF=y > CONFIG_BINFMT_MISC=m > CONFIG_BLK_DEV_FD=m > CONFIG_BLK_DEV_IDE=y > CONFIG_BLK_DEV_IDEDISK=y > CONFIG_BLK_DEV_IDECD=m > CONFIG_BLK_DEV_IDEPCI=y > CONFIG_BLK_DEV_IDEDMA=y > CONFIG_IDEDMA_AUTO=y > CONFIG_BLK_DEV_LOOP=m > CONFIG_PARIDE_PARPORT=y > CONFIG_PACKET=y > CONFIG_UNIX=y > CONFIG_INET=y > CONFIG_IP_NOSR=y > CONFIG_NETDEVICES=y > CONFIG_DUMMY=m > CONFIG_NET_ETHERNET=y > CONFIG_NET_ISA=y > CONFIG_NE2000=m > CONFIG_PPP=m > CONFIG_SLIP=m > CONFIG_SLIP_COMPRESSED=y > CONFIG_SLIP_SMART=y > CONFIG_VT=y > CONFIG_VT_CONSOLE=y > CONFIG_SERIAL=y > CONFIG_RTC=y > CONFIG_NVRAM=m > CONFIG_EXT2_FS=y > CONFIG_ISO9660_FS=m > CONFIG_JOLIET=y > CONFIG_FAT_FS=y > CONFIG_MSDOS_FS=m > CONFIG_VFAT_FS=y > CONFIG_PROC_FS=y > CONFIG_NFS_FS=m > CONFIG_NFSD=m > CONFIG_SUNRPC=m > CONFIG_LOCKD=m > CONFIG_NLS=y > CONFIG_NLS_CODEPAGE_437=m > CONFIG_NLS_CODEPAGE_866=m > CONFIG_NLS_ISO8859_1=m > CONFIG_NLS_KOI8_R=m > CONFIG_VGA_CONSOLE=y > CONFIG_SOUND=m > CONFIG_SOUND_OSS=m > CONFIG_SOUND_SB=m > CONFIG_SOUND_ADLIB=m > CONFIG_SOUND_SOFTOSS=m > CONFIG_SOUND_YM3812=m > CONFIG_MAGIC_SYSRQ=y > > Bye, > Oleg > - -- > [RAVE *SUCKS* TEAM] [Team $Ui(iDE] [Trans-M Must Die!] [Sepultura Fans Team] > [Tolkien forever team]- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/faq.html