Which SCSI controller is giving the reset errors? Which device? What's
the status of tagged queueing on your setup? Does it identify the
device before the problems start? What happens if you use the
aic7xxx=no_reset flag on bootup?
> I have two host adapters:
>
> Adaptec AHA-294X Ultra2 SCSI host adapter
> Ultra2-LVD/SE Wide Controller
>
> Adaptec AHA-294X Ultra SCSI host adapter
> Ultra Narrow Controller
>
> ...and three scsi devices:
>
> Host: scsi0 Channel: 00 Id: 00 Lun: 00
> Vendor: IBM Model: DRVS09V Rev: 00F0
> Type: Direct-Access ANSI SCSI revision: 02
> Host: scsi1 Channel: 00 Id: 01 Lun: 00
> Vendor: QUANTUM Model: VIKING 2.3 NSE Rev: 8808
> Type: Direct-Access ANSI SCSI revision: 02
> Host: scsi1 Channel: 00 Id: 04 Lun: 00
> Vendor: ARCHIVE Model: Python 28388-XXX Rev: 5.45
> Type: Sequential-Access ANSI SCSI revision: 02
>
>
> Back to 5.1.10 and all is fine.
>
> Michael
>
> --
>
> Michael Nelson San Francisco, CA nelson@imat.com
-- Doug Ledford <dledford@redhat.com> Opinions expressed are my own, but they should be everybody's.- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/