> I have been trying to get a ISA Multitech ISI4608 Card to work under
> Linux. I can get it to work under 2.0.36 (RH5.2) with the driver available
> from ftp.multitech.com, however I cannot get it to work with the driver
> for isicom cards in 2.2.9.
>
> What happens is, the driver loads, and the firmware loads OK. I open up
> minicom, tell it to use the appropriate device. It initializes the modem,
> the modem responds to this, but minicom never prints out anything (it
> normally prints the AT command and the response). I can dial out, the
> modem connects, but minicom never acknowledges this. It is like the data
> is only travelling in one direction.
>
> I have played around with isicom.c a little bit, it seems like the problem
> is that the interrupt routine is never called. I don't know if this is
> something caused by the card not being initialized properly or if it is
> caused by the routine not being registered properly. I am not an
> experienced kernel hacker so I don't know if there has been a change that
> has caused this or not.
>
> I have tried both the firmware available from Multitech and the firmware
> RPM mentioned at the top of isicom.c in 2.2.x. Neither work any better or
> worse than the other. If someone knows any more about this, I'd be
> grateful for your help. Thanks.
When you load the module, what options are you passing to it and how?
I have a ISI card that has been working just nifty with 2.2.x...
--
Tom Cross Voice: 320-253-1020 FAX: 320-253-6956
System Administrator E-mail: tomc@kendeco.com
Airgas Kendeco Tool Crib http://www.kendeco.com
--> Now with new and improved extension number 207!!! <--
St Cloud Area Linux Users Group: http://www.scalug.org
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/