my system :
IDE & SCSI (mix).. std intel Zappa ZP board and Buslogic controller.
SCSI disk is a removable JAZ.
PCI devices found:
Bus 0, device 0, function 0:
Host bridge: Intel 82437 (rev 1).
Medium devsel. Master Capable. Latency=64.
Bus 0, device 7, function 0:
ISA bridge: Intel 82371FB PIIX ISA (rev 2).
Medium devsel. Fast back-to-back capable. Master Capable. No bursts.
Bus 0, device 7, function 1:
IDE interface: Intel 82371FB PIIX IDE (rev 2).
Medium devsel. Fast back-to-back capable. Master Capable. Latency=64.
I/O at 0xffa0 [0xffa1].
Bus 0, device 13, function 0:
Ethernet controller: Realtek 8029 (rev 0).
Medium devsel. IRQ 5.
I/O at 0xff80 [0xff81].
Bus 0, device 14, function 0:
SCSI storage controller: BusLogic FlashPoint (rev 2).
Fast devsel. IRQ 9. Master Capable. Latency=64. Min Gnt=8.Max Lat=8.
I/O at 0xfc00 [0xfc01].
Non-prefetchable 32 bit memory at 0xffbef000 [0xffbef000].
Bus 0, device 15, function 0:
VGA compatible device: S3 Inc. Vision 864-P (rev 0).
Medium devsel.
Non-prefetchable 32 bit memory at 0xff000000 [0xff000000].
Attached devices:
Host: scsi0 Channel: 00 Id: 04 Lun: 00
Vendor: iomega Model: jaz 1GB Rev: J.86
Type: Direct-Access ANSI SCSI revision: 02
***** BusLogic SCSI Driver Version 2.1.15 of 17 August 1998 *****
Copyright 1995-1998 by Leonard N. Zubkoff <lnz@dandelion.com>
Configuring BusLogic Model BT-930 PCI Ultra SCSI Host Adapter
Firmware Version: 5.02, I/O Address: 0xFC00, IRQ Channel: 9/Level
PCI Bus: 0, Device: 14, Address: 0xFFBEF000, Host Adapter SCSI ID: 7
Parity Checking: Disabled, Extended Translation: Enabled
Synchronous Negotiation: UUUUFUU#, Wide Negotiation: Disabled
Disconnect/Reconnect: Enabled, Tagged Queuing: Enabled
Driver Queue Depth: 255, Scatter/Gather Limit: 128 segments
Tagged Queue Depth: Automatic, Untagged Queue Depth: 3
Error Recovery Strategy: Default, SCSI Bus Reset: Enabled
SCSI Bus Termination: Enabled, SCAM: Disabled
*** BusLogic BT-930 Initialized Successfully ***
Target 4: Queue Depth 3, Synchronous at 10.0 MB/sec, offset 15
Current Driver Queue Depth: 255
Currently Allocated CCBs: 28
DATA TRANSFER STATISTICS
Target Tagged Queuing Queue Depth Active Attempted Completed
====== ============== =========== ====== ========= =========
4 Not Supported 3 0 48634 48634
Target Read Commands Write Commands Total Bytes Read Total Bytes Written
====== ============= ============== =================== ===================
4 42530 6065 207261696 31768576
Target Command 0-1KB 1-2KB 2-4KB 4-8KB 8-16KB
====== ======= ========= ========= ========= ========= =========
4 Read 0 28505 4685 3617 3214
4 Write 0 3885 1429 361 144
Target Command 16-32KB 32-64KB 64-128KB 128-256KB 256KB+
====== ======= ========= ========= ========= ========= =========
4 Read 684 1217 608 0 0
4 Write 61 30 155 0 0
ERROR RECOVERY STATISTICS
Command Aborts Bus Device Resets Host Adapter Resets
Target Requested Completed Requested Completed Requested Completed
ID \\\\ Attempted //// \\\\ Attempted //// \\\\ Attempted ////
====== ===== ===== ===== ===== ===== ===== ===== ===== =====
4 0 0 0 0 0 0 0 0 0
External Host Adapter Resets: 0
Host Adapter Internal Errors: 0
-- Grobbebol's Home | Don't give in to spammers. http://www.xs4all.nl/~bengel | Use your real e-mail address Linux 2.0.34 on an i586/64 MB | on Usenet.- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/