Re: UDMA and VIA APOLLO CHIPSET

Sid Boyce (szb50@amdahl.com)
Mon, 05 Jul 1999 20:43:36 +0100

It could be a cable problem, I re-checked yesterday when booting up
2.2.10-ac7 and UDMA was enabled in the BIOS. This is what I see in
dmesg.
VP_IDE: IDE controller on PCI bus 00 dev 39
VP_IDE: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xe000-0xe007, BIOS settings: hda:DMA, hdb:DMA
ide0: VIA Bus-Master (U)DMA Timing Config Success
ide1: BM-DMA at 0xe008-0xe00f, BIOS settings: hdc:DMA, hdd:DMA
ide1: VIA Bus-Master (U)DMA Timing Config Success
hda: Maxtor 91080D5, ATA DISK drive
hdc: IBM-DHEA-36480, ATA DISK drive
hdd: SANYO CRD-820P, ATAPI CDROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
Regards
-- 
... Sid Boyce...Amdahl(Europe)...44-121 422 0375 
Any opinions expressed above are mine and do not necessarily represent
 the opinions or policies of Amdahl Corporation.






-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/