/dev/hda:
Timing buffered disk reads: 64 MB in 6.15 seconds =10.41 MB/sec
/dev/sda:
Timing buffered disk reads: 64 MB in 13.64 seconds = 4.69 MB/sec
And another:
time tar -xzf /home/jrduchek/X335src-1.tgz
6.910u 4.760s 0:24.70 47.2% 0+0k 0+0io
4486pf+0w IDE
time tar -xzf /home/jrduchek/X335src-1.tgz
6.600u 3.910s 0:31.58 33.2% 0+0k 0+0io
4480pf+0w SCSI
The system is a K6-III 450, 192M of RAM, the SCSI card has 4M cache on
it.
Any ideas? Who should I email about questions on the driver, I imagine
AMI themselves will tell me they don't officially support it. Am I
missing something?
Thanks in advance. PS the following is information that might be of
use.
from /proc/pci: Bus 0, device 9, function 0:
Unknown mass storage controller: Unknown vendor Unknown device (rev
3).
Vendor id=101e. Device id=9010.
Medium devsel. IRQ 10. Master Capable. Latency=64.
I/O at 0xec00 [0xec01].
from scsiinfo
[jrduchek@joe megaraid]# scsiinfo -a /dev/sda
Scsiinfo version 1.7(eowmob)
Inquiry command
---------------
Relative Address 0
Wide bus 32 0
Wide bus 16 1
Synchronous neg. 1
Linked Commands 0
Command Queueing 1
SftRe 0
Device Type 0
Peripheral Qualifier 0
Removable? 0
Device Type Modifier 0
ISO Version 0
ECMA Version 0
ANSI Version 2
AENC 0
TrmIOP 0
Response Data Format 0
Vendor: MegaRAID
Product: LD0 RAID0 4094R
Revision level: M.73
Serial Number ''
Data from Rigid Disk Drive Geometry Page
----------------------------------------
Number of cylinders 0
Number of heads 0
Starting write precomp 0
Starting reduced current 0
Drive step rate 0
Landing Zone Cylinder 0
RPL 0
Rotational Offset 0
Rotational Rate 0
Data from Caching Page
----------------------
Write Cache 0
Read Cache 1
Prefetch units 0
Demand Read Retention Priority 0
Demand Write Retention Priority 0
Disable Pre-fetch Transfer Length 0
Minimum Pre-fetch 0
Maximum Pre-fetch 0
Maximum Pre-fetch Ceiling 0
Data from Format Device Page
----------------------------
Removable Medium 0
Supports Hard Sectoring 0
Supports Soft Sectoring 0
Addresses assigned by surface 0
Tracks per Zone 0
Alternate sectors per zone 0
Alternate tracks per zone 0
Alternate tracks per lun 0
Sectors per track 0
Bytes per sector 0
Interleave 0
Track skew factor 0
Cylinder skew factor 0
Data from Error Recovery Page
-----------------------------
AWRE 0
ARRE 0
TB 0
RC 0
EER 0
PER 0
DTE 0
DCR 0
Read Retry Count 0
Correction Span 0
Head Offset Count 0
Data Strobe Offset Count 0
Write Retry Count 0
Recovery Time Limit 0
Data from Control Page
----------------------
RLEC 0
QErr 0
DQue 0
EECA 0
RAENP 0
UUAENP 0
EAENP 0
Queue Algorithm Modifier 0
Ready AEN Holdoff Period 0
Data from Disconnect-Reconnect Page
-----------------------------------
Buffer full ratio 0
Buffer empty ratio 0
Bus Inactivity Limit 0
Disconnect Time Limit 0
Connect Time Limit 0
Maximum Burst Size 0
DTDC 0x0
Data from Defect Lists
----------------------
Unable to read manufacturer defect data.
Unable to read grown defect data.
Data from Notch Parameters Page
-------------------------------
Notched Drive 0
Logical or Physical Notch 0
Max # of notches 0
Active Notch 0
Starting Boundary 0x0
Ending Boundary 0x0
Pages Notched 00000000 00000000
Data from Verify Error Recovery Page
------------------------------------
EER 0
PER 0
DTE 0
DCR 0
Verify Retry Count 0
Verify Correction Span (bits) 0
Verify Recovery Time Limit (ms) 0
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/