Re: ESS Solo 1 MIDI

Ari Pollak (compwiz@bigfoot.com)
Fri, 24 Sep 1999 15:56:53 -0400 (EDT)

Thanks.. that's the one thing i forgot to do - There were no kernel
messages and I almost gave up, until I figured I'd try setting the io
address.. First I figured I'd try the default, 0x388, to no avail, and not
knowing the IO address of MIDI for solo1.. So I ended up checking
/proc/pci for all the I/O addresses of the card. Finally, after trial and
error of checking each IO address, I finally found that 0x1050 works as
the MIDI address. So, for anyone trying to get MIDI to work on the opl3,
use IO port 0x1050 :) I'm surprised this thing actually works in the
first place considering it's practically the winmodem of soundcards.

On Fri, 24 Sep 1999, Thomas Sailer wrote:

> Ari Pollak wrote:
> >
> > Hm... applied the patch, recompiled the module, but still does the same
> > thing.
>
> Have you loaded the opl3 module? Any kernel message? You likely need
> to specify the io address on the module command line.
>
> Tom
>

----------------------------------------------------------------
Ari Pollak - compwiz@bigfoot.com - www.compwiz.nu
"It is not only fine feathers that make fine birds."
ICQ #749825 - AOL IM: aripollak

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/