Andre Hedrick
The Linux IDE guy
On Sat, 25 Sep 1999, Donald A. Huettl wrote:
> The PCI controller on Cable Port 1 is not detected on my Abit BP6 (Cable
> Port 0 is
> found). Kernel 2.3.12 worked. Kernel 2.3.18ac8 does not. The small
> diff below
> fixed my particular environment.
>
> Thanks
>
> DH
> Setup:
> Abit BP6 dual Celeron board with two 366MHz CPUs
> SMP kernel 2.3.18ac8
>
>
> + diff /usr/src/linux/drivers/block/ide-pci.c.ac8
> /usr/src/linux/drivers/block/ide-pci.c.DAH
> 614c614
> < if (dev2 && !hpt363_shared_irq) {
> ---
> > if (dev2) {
>
>
> # --------- part of /var/log/messages after my small change
> ----------------Sep 25 22:23:38 fs1 syslogd 1.3-3: restart.
> Sep 25 22:23:38 fs1 syslog: syslogd startup succeeded
> Sep 25 22:23:38 fs1 kernel: klogd 1.3-3, log source = /proc/kmsg
> started.
> Sep 25 22:23:38 fs1 kernel: Inspecting /boot/System.map-2.3.18ac8
> .
> .
> Sep 25 22:23:38 fs1 kernel: Uniform Multi-Platform E-IDE driver
> Revision: 6.20
> Sep 25 22:23:38 fs1 kernel: PIIX4: IDE controller on PCI bus 00 dev 39
> Sep 25 22:23:38 fs1 kernel: PIIX4: not 100% native mode: will probe irqs
> later
> Sep 25 22:23:38 fs1 kernel: ide0: BM-DMA at 0xf000-0xf007, BIOS
> settings: hda:DMA, hdb:pio
> Sep 25 22:23:38 fs1 kernel: ide1: BM-DMA at 0xf008-0xf00f, BIOS
> settings: hdc:DMA, hdd:pio
> Sep 25 22:23:38 fs1 kernel: HPT366: onboard version of chipset, pin1=1
> pin2=2
> Sep 25 22:23:38 fs1 kernel: HPT366: IDE controller on PCI bus 00 dev 98
> Sep 25 22:23:38 fs1 kernel: HPT366: not 100% native mode: will probe
> irqs later
> Sep 25 22:23:38 fs1 kernel: HPT366: reg5ah=0x01 ATA-66 Cable Port0
> Sep 25 22:23:38 fs1 kernel: ide2: BM-DMA at 0xe000-0xe007, BIOS
> settings: hde:pio, hdf:pio
> Sep 25 22:23:38 fs1 kernel: HPT366: IDE controller on PCI bus 00 dev 99
> Sep 25 22:23:38 fs1 kernel: HPT366: not 100% native mode: will probe
> irqs later
> Sep 25 22:23:38 fs1 kernel: HPT366: reg5ah=0x01 ATA-66 Cable Port1
> Sep 25 22:23:38 fs1 kernel: ide3: BM-DMA at 0xec00-0xec07, BIOS
> settings: hdg:pio, hdh:pio
> Sep 25 22:23:38 fs1 kernel: hda: Maxtor 91152D8, ATA DISK drive
> Sep 25 22:23:38 fs1 kernel: hdc: CD-524EA, ATAPI CDROM drive
> Sep 25 22:23:38 fs1 kernel: hde: IBM-DJNA-371350, ATA DISK drive
> Sep 25 22:23:38 fs1 kernel: hdg: IBM-DJNA-371350, ATA DISK drive
> Sep 25 22:23:38 fs1 kernel: ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
> Sep 25 22:23:38 fs1 kernel: ide1 at 0x170-0x177,0x376 on irq 15
> Sep 25 22:23:38 fs1 kernel: ide2 at 0xd800-0xd807,0xdc02 on irq 11
> Sep 25 22:23:38 fs1 kernel: ide3 at 0xe400-0xe407,0xe802 on irq 11
> Sep 25 22:23:38 fs1 kernel: hda: Maxtor 91152D8, 10991MB w/256kB Cache,
> CHS=1401/255/63, UDMA(33)
> Sep 25 22:23:38 fs1 kernel: hde: UDMA 4 drive0 (0x90c9a731 0x10c9a731)
> 0x0000
> Sep 25 22:23:38 fs1 kernel: hde: IBM-DJNA-371350, 12949MB w/1966kB
> Cache, CHS=26310/16/63, UDMA(66)
> Sep 25 22:23:38 fs1 kernel: hdg: UDMA 4 drive0 (0x90c9a731 0x10c9a731)
> 0x0000
> Sep 25 22:23:38 fs1 kernel: hdg: IBM-DJNA-371350, 12949MB w/1966kB
> Cache, CHS=26310/16/63, UDMA(66)
> Sep 25 22:23:38 fs1 kernel: hdc: ATAPI 24X CD-ROM drive, 128kB Cache,
> DMA
> Sep 25 22:23:38 fs1 kernel: Uniform CDROM driver Revision: 3.04
> Sep 25 22:23:38 fs1 kernel: Floppy drive(s): fd0 is 1.44M
> Sep 25 22:23:38 fs1 kernel: FDC 0 is a post-1991 82077
> Sep 25 22:23:38 fs1 kernel: md driver 0.36.6 MAX_MD_DEV=4, MAX_REAL=8
>
>
>
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/