Getting ISDN Card working (was vendor ID in /proc/pci)

Russell Foster (rfoster@tele2.net.uk)
Tue, 28 Sep 1999 15:25:52 +0100

HI All,
I'm not sure if this is the place to raise this issue about
configuring the ISDN card but I'll try anyway or if some could point me in
the right direction. Thanks to all those who helped me I finally found out
my card was a Datalink but that is as far as I managed to get. I managed to
lay my hands on some drivers for the dynalink card built against 2.2.12. I
tried to load these using modprobe hisax but this just comes pack with

/lib/modules/2.2.12/misc/isdn.o: init_module: Device or resource busy
isdn: No such file or directory

however dmesg shows

ISDN subsystem Rev: 1.86/1.72/1.88/1.49/1.16/1.2
HiSax: Linux Driver for passive ISDN cards
HiSax: Version 3.3 (kernel)
HiSax: Layer1 Revision 2.34
HiSax: Layer2 Revision 2.19
HiSax: TeiMgr Revision 2.13
HiSax: Layer3 Revision 2.10
HiSax: LinkLayer Revision 2.31
HiSax: Approval certification valid
HiSax: Approved with ELSA Quickstep series cards
HiSax: Approval registration numbers:
HiSax: German D133361J CETECOM ICT Services GmbH
HiSax: EU (D133362J) CETECOM ICT Services GmbH
HiSax: Approved with Eicon Technology Diva 2.01 PCI cards
HiSax: Total 1 card defined
HiSax: Card 1 Protocol 1TR6 Id=HiSAX (0)
HiSax: Support for ISDNLink Card not selected
HiSax: Card ISDNLink not installed !

I have read the all the documentation I can find such as the documents
bundleed with the soure code and also the FAQ supplied with isdn4k-utils.
Can anyone help or pointme somewhere more appropiate to point this
question? TIA

Rus

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/