PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: not 100% native mode: will probe irqs later
ide1: BM-DMA at 0x1408-0x140f, BIOS settings: hdc:pio, hdd:pio
hdc: R/RW 4x4x24, ATAPI CDROM drive
hdd: IOMEGA ZIP 100 ATAPI, ATAPI FLOPPY drive
ide1 at 0x170-0x177,0x376 on irq 15
hdc: ATAPI 24X CD-ROM CD-R/RW drive, 2048kB Cache
Uniform CDROM driver Revision: 2.56
hdd: 98304kB, 96/64/32 CHS, 4096 kBps, 512 sector size, 2941 rpm
hdd: The drive reports both 100663296 and 0 bytes as its capacity
Floppy drive(s): fd0 is 1.44M
Uhhuh. NMI received. Dazed and confused, but trying to continue
You probably have a hardware problem with your RAM chips
I would be worried by this. Check whether your memory is OK.
kmod: failed to exec /sbin/modprobe -s -k block-major-3, errno = 2
And you are not building your system with ide as a module where the
module has to be loaded from IDE disk?
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/