Re: Help! with Linksys Etherfast LNE 100 TX

daveflory@attglobal.net
Thu, 02 Dec 1999 16:22:11 -0800

Try copying the tulip.c driver that is included on the Linksys Disk 2
onto /usr/src/linux/drivers/net and then recompile the kernel with the
tulip driver enabled. For some reason the lastest tulip.c drivers, as
well as the ones included with RH, do not work with the Linksys card.
However, the older modified driver on the Linksys diskette does.

Regards,

David Flory

yangboy@math.ntu.edu.tw wrote:
>
> Hello!
>
> I bought a "Switched network in a box" kit from Cyberian Outpost
> after reading an article in Linux Journal. But I am having problems just
> getting the included 10/100 PCI NICs to run. When I try to use DEC Tulip
> drivers, I get "Delayed eth0 initialization" when booting and dmesg shows
> "unknown Tulip type PCI NIC" or something similar. Can someone help? I'm
> running a straight Red Hat Linux 6.1 out of the box on a old PII/233.
>
> The card has a sticker with "Linksys C98-00538247 LNE100A0" on
> the back and the chip in front says Linksys LNE100TX ....."
>
> Thanks in advance for any help rendered or any tips ...

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/