[PATCH 05/22] PCI: mediatek: Use SET_PCI_ERROR_RESPONSE() when device not found

[Naveen Naidu]

An MMIO read from a PCI device that doesn't exist or doesn't respond
causes a PCI error.  There's no real data to return to satisfy the
CPU read, so most hardware fabricates ~0 data.

Use SET_PCI_ERROR_RESPONSE() to set the error response, when a faulty
read occurs.

This helps unify PCI error response checking and make error check
consistent and easier to find.

Compile tested only.

Signed-off-by: Naveen Naidu <naveennaidu479@xxxxxxxxx>
---
 drivers/pci/controller/pcie-mediatek.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/pci/controller/pcie-mediatek.c b/drivers/pci/controller/pcie-mediatek.c
index 2f3f974977a3..aa744ccd1a2a 100644
--- a/drivers/pci/controller/pcie-mediatek.c
+++ b/drivers/pci/controller/pcie-mediatek.c
@@ -369,13 +369,13 @@ static int mtk_pcie_config_read(struct pci_bus *bus, unsigned int devfn,
 
 	port = mtk_pcie_find_port(bus, devfn);
 	if (!port) {
-		*val = ~0;
+		SET_PCI_ERROR_RESPONSE(val);
 		return PCIBIOS_DEVICE_NOT_FOUND;
 	}
 
 	ret = mtk_pcie_hw_rd_cfg(port, bn, devfn, where, size, val);
 	if (ret)
-		*val = ~0;
+		SET_PCI_ERROR_RESPONSE(val);
 
 	return ret;
 }
-- 
2.25.1