Re: [PATCH v11 1/3] dt-bindings: iio: adc: add max14001

[Conor Dooley]

On Sat, Sep 20, 2025 at 06:44:52PM -0300, Marcelo Schmitt wrote:
> ...
> > 
> > > > +  interrupts:
> > > > +    minItems: 1
> > > > +    items:
> > > > +      - description: |
> > > > +          Asserts high when ADC readings exceed the upper threshold and low
> > > > +          when below the lower threshold. Must be connected to the COUT pin.
> > > > +      - description: |
> > > > +          Alert output that asserts low during a number of different error
> > > > +          conditions. The interrupt source must be attached to FAULT pin.
> > 
> > These descriptions read wrong to me. They __are__ the COUT and FAULT
> > pins, given what David responded to above, not something that can be
> > connected to these pins (if they were, they would be represented as
> > -gpios rather than interrupts most likely). Unless you mean that these
> > pins can have some other use and are only available on the COUT/FAULT
> > pins when some register value is set - but even in that case saying
> > "must be" doesn't fit since the interrupt property could be used to
> > configure the device accordingly.
> 
> COUT and FAULT are just two pins on the ADC chip that can be used to generate
> interrupts. Would a description like the one below sound better?
> 
>   interrupts:
>     minItems: 1
>     items:
>       - description: |
>           cout: Comparator output signal that asserts high when ADC readings
>           exceed the upper threshold and low when readings fall below the lower
>           threshold.

I think you should mention the pin name here, like you did below.
"asserts high on the COUT pin" or w/e.

>       - description: |
>           fault: When fault reporting is enabled, the FAULT pin is asserted low
>           whenever one of the monitored fault conditions occurs.
> 
> Best regards,
> Marcelo

Attachment: signature.asc
Description: PGP signature