Re: [PATCH v2] arm64: dts: qcom: glymur-crd: Move common board nodes to shared DTSI

[Gopikrishna Garmidi]

On 5/19/2026 7:55 PM, Gopikrishna Garmidi wrote:
> The Glymur and Mahua CRDs use the same board-level hardware for the
> eDP display panel, MDSS DP3 controller and PHY, USB-C ports (via
> pmic-glink), USB 0/1/HS/MP controllers, QMP PHYs, eUSB2 repeaters,
> HID peripherals (touchpad, keyboard, touchscreen) and their dependent
> regulators and pin control states. This has been verified against
> both CRD schematics.
>
> Move these nodes from glymur-crd.dts to glymur-crd.dtsi to enable code
> reuse with the Mahua CRD.
>
> Signed-off-by: Gopikrishna Garmidi <gopikrishna.garmidi@xxxxxxxxxxxxxxxx>
> ---
> Changes in v2:
> - Rebased on top of next-20260518
> - Updated subject to include glymur-crd scope prefix
> - Rewrote commit message to describe the actual shared physical hardware
>    rather than the code-sharing intent; the commonality was verified
>    against Glymur CRD and Mahua CRD schematics
> - Link to v1: https://lore.kernel.org/r/20260326-glymur-mahua-common-nodes-v1-1-12bb26920ea4@xxxxxxxxxxxxxxxx
> ---
>   arch/arm64/boot/dts/qcom/glymur-crd.dts  | 399 -------------------------------
>   arch/arm64/boot/dts/qcom/glymur-crd.dtsi | 396 ++++++++++++++++++++++++++++++
>   2 files changed, 396 insertions(+), 399 deletions(-)


Hi Krzysztof, Konrad,

This has been waiting for a while now and already has a Reviewed-by from 
Dmitry. Could you take a look when you get a chance?

Thanks,
Gopikrishna Garmidi