Re: [PATCH 1/4] arm64: dts: qcom: glymur-crd: Update VREG l2b_e0 and l9b_e0 voltage for SD-card

[Konrad Dybcio]

On 6/10/26 1:15 PM, Monish Chunara wrote:
> From: Kamal Wadhwa <kamal.wadhwa@xxxxxxxxxxxxxxxx>
> 
> SD cards may need 1.8v VDDIO also to be supported, to accommodate this
> requirement reduce the min voltage to 1.8v for `vreg_l2b_e0` which
> supplies to VDDIO pin of SD card.
> 
> NOTE - Since this SD card is the only client on this regulator, this
> change should not have any side effect on any other clients.
> moreover, SD card driver takes care to explicitly vote for the
> regulator voltage based on the SD card detection sequence.
> 
> Also for stable operation of the SD card increase VDD voltage
> supplied by `vreg_l9b_e0` to 2.96v.

Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxxxxxxxx>

Konrad