[PATCH v2 0/4] Add support for AD3532R/AD3532

[Kim Seer Paller]

This series adds support for the AD3532R/AD3532, a 16-channel, 16-bit
voltage output DAC, to the existing ad3530r driver.

The AD3532R is part of the AD3530R family and shares similar
functionality (channel configuration, LDAC triggering, powerdown
control). It extends the existing ad3530r driver as the underlying
workflow remains the same. The main difference being the register
address map due to the dual-bank architecture, which is handled
by table-driven helpers introduced in this series.

The AD3532R uses a dual-bank register architecture (bank 0 at 0x1000
for channels 0-7, bank 1 at 0x3000 for channels 8-15). Per-chip
register address arrays in chip_info are iterated by bank helpers,
replacing single-register setup calls for existing variants and scaling
naturally to the AD3532R's dual-bank layout.

The series also adds AD3532R-specific powerdown modes (1kohm_to_gnd,
10kohm_to_gnd, three_state) and a new ABI entry for the 10kohm_to_gnd
powerdown mode.

Datasheet: https://www.analog.com/media/en/technical-documentation/data-sheets/ad3532r.pdf

Signed-off-by: Kim Seer Paller <kimseer.paller@xxxxxxxxxx>
---
Changes in v2:
- Split AD3532R patch into refactor only and new device support patches.
- Add ad3530r_set_reg_bank_bits() helper for set-bits call sites.
- Use for (unsigned int i = 0; ...) in bank helpers.
- Add per-chip regmap_config to limit debugfs register space per variant.
- Switch spi_device_id to named initializers.
- Fix line wrapping in ad3532r_set_dac_powerdown().
- Link to v1: https://patch.msgid.link/20260604-iio-ad3532r-support-v1-0-c3552f9031de@xxxxxxxxxx

To: Nuno Sá <nuno.sa@xxxxxxxxxx>
To: Michael Hennerich <Michael.Hennerich@xxxxxxxxxx>
To: Kim Seer Paller <kimseer.paller@xxxxxxxxxx>
To: Jonathan Cameron <jic23@xxxxxxxxxx>
To: David Lechner <dlechner@xxxxxxxxxxxx>
To: Andy Shevchenko <andy@xxxxxxxxxx>
To: Rob Herring <robh@xxxxxxxxxx>
To: Krzysztof Kozlowski <krzk+dt@xxxxxxxxxx>
To: Conor Dooley <conor+dt@xxxxxxxxxx>
Cc: linux-iio@xxxxxxxxxxxxxxx
Cc: linux@xxxxxxxxxx
Cc: linux-kernel@xxxxxxxxxxxxxxx
Cc: devicetree@xxxxxxxxxxxxxxx

---
Kim Seer Paller (4):
      iio: dac: ad3530r: Refactor setup to table-driven register bank approach
      iio: ABI: add DAC 10kohm_to_gnd powerdown mode
      dt-bindings: iio: dac: add support for AD3532R/AD3532
      iio: dac: ad3530r: Add support for AD3532R/AD3532

 Documentation/ABI/testing/sysfs-bus-iio            |   1 +
 .../devicetree/bindings/iio/dac/adi,ad3530r.yaml   |  16 +-
 drivers/iio/dac/Kconfig                            |   4 +-
 drivers/iio/dac/ad3530r.c                          | 352 ++++++++++++++++++---
 4 files changed, 326 insertions(+), 47 deletions(-)
---
base-commit: a50909aa46dec46de3c73235fc15a7d6f763d996
change-id: 20260604-iio-ad3532r-support-759067e904e1

Best regards,
--  
Kim Seer Paller <kimseer.paller@xxxxxxxxxx>