Re: [PATCH 2/3] arm64: dts: qcom: eliza-evk: Add PCIe1 with TC9563 PCIe switch

[Konrad Dybcio]

On 7/6/26 7:22 AM, Krishna Chaitanya Chundru wrote:
> 
> 
> On 7/3/2026 8:39 PM, Konrad Dybcio wrote:
>> On 7/3/26 2:38 PM, Krishna Chaitanya Chundru wrote:
>>> The Eliza EVK board connects PCIe1 (8GT/s x2) to a Toshiba TC9563
>>> PCIe switch. Enable PCIe1 and its QMP PHY nodes.
>>>
>>> TC9563 uses I2C (at address 0x77 on I2C4) for its management interface.
>>>
>>> Override the base iommu-map with the expanded set covering all the
>>> switch's downstream ports (0x1400-0x1408 SID range).
>>>
>>> The TC9563 RESX# and PERST# are OR-ed internally to assert reset on the
>>> switch. Use TC9563 RESX# pin via a TLMM GPIO and skip wiring PERST#
>>> from the PCIe controller.
>>>
>>> Signed-off-by: Krishna Chaitanya Chundru <krishna.chundru@xxxxxxxxxxxxxxxx>
>>> ---
>> [...]
>>
>>> +&pcie1 {
>>> +	pinctrl-names = "default";
>>> +	pinctrl-0 = <&pcie1_default_state>;
>> flipped order
>>
>> [...]
>>
>>> +&pcie1port0 {
>> This port should also get the compatible
> for pcie1 it is not required, only for m.2 connector we need the compatible.

It will be required once someone else makes a board where this
PCIe slot is routed

Replying back and forth took more time than fixing the issue

Konrad