Re: [PATCH v2 2/4] arm64: dts: qcom: shikra-cqm-evk: Enable display and add ili7807s panel

[Arpit Saini]

Hi Konrad,

On 7/6/2026 3:33 PM, Konrad Dybcio wrote:
> On 7/6/26 8:04 AM, Nabige Aala wrote:
> > From: Arpit Saini <arpit.saini@xxxxxxxxxxxxxxxx>
> >
> > Enable the Qualcomm Shikra MDSS display subsystem on the Shikra CQM EVK
> > board and add the DLC0697 MIPI DSI display panel node. Pin pm4125_l5
> > to 1.232V with regulator-allow-set-load for DSI PHY PLL stability.
> >
> > Signed-off-by: Arpit Saini <arpit.saini@xxxxxxxxxxxxxxxx>
> > Signed-off-by: Nabige Aala <nabige.aala@xxxxxxxxxxxxxxxx>
> > ---
> [...]
>
> > +	panel_bl_en: panel-bl-en-state {
> > +		pins = "gpio91";
> > +		function = "gpio";
> > +		drive-strength = <2>;
> > +		bias-disable;
> > +		output-high;
> > +	};
> > +
> > +	panel_bl_en_suspend: panel-bl-en-suspend-state {
> > +		pins = "gpio91";
> > +		function = "gpio";
> > +		drive-strength = <2>;
> > +		bias-pull-down;
> > +		output-low;
> > +	};
> output-foo isn't necessary, the panel driver will assert it as
> necessary
>
> Konrad

Ack, thanks for pointing out.

Arpit