[PATCH 0/6] Add SpacemiT K1 USB2.0 controllers support

[Junzhong Pan]

The SpacemiT K1 SoC has two USB2.0 controllers, one has Dual-Role
support, but the hardware has no internal OTG registers, the other is
Host only. These controllers are compatible with Chipidea USB2 driver
with some flags set and reset control support.

This series is based on 7.2-rc1 and has been tested on Banana Pi F3
development board.

A self-powered USB device/hub is needed to test the host function of the
dual-role controller on Banana Pi F3, a MINI-PCIe USB2.0 module (a
cellular module e.g.) is needed to test the host only controller.

Signed-off-by: Junzhong Pan <panjunzhong@xxxxxxxxxxxxxxxxxx>
---
Junzhong Pan (6):
      dt-bindings: usb: ci-hdrc-usb2: add spacemit,k1-usb2 compatible
      usb: chipidea: usb2: add optional reset support
      usb: chipidea: usb2: add SpacemiT K1 support
      riscv: dts: spacemit: add USB2.0 controller nodes for K1
      riscv: dts: spacemit: enable USB2.0 controllers on BananaPi F3
      riscv: defconfig: enable ChipIdea USB controller support

 .../devicetree/bindings/usb/ci-hdrc-usb2.yaml      |  1 +
 arch/riscv/boot/dts/spacemit/k1-bananapi-f3.dts    | 16 +++++++++
 arch/riscv/boot/dts/spacemit/k1.dtsi               | 40 ++++++++++++++++++++++
 arch/riscv/configs/defconfig                       |  4 +++
 drivers/usb/chipidea/ci_hdrc_usb2.c                | 16 +++++++++
 5 files changed, 77 insertions(+)
---
base-commit: dc59e4fea9d83f03bad6bddf3fa2e52491777482
change-id: 20260812-b4-spacemit-k1-usb2-97adfc283d58

Best regards,
-- 
Junzhong Pan <panjunzhong@xxxxxxxxxxxxxxxxxx>