Re: [PATCH v2] misc: fix typos in comments

[Vishnu Dasa]

On Mon, Oct 5, 2026 at 11:01 PM Hemanth Selam <hemanth.selam@xxxxxxxxx> wrote:
>
> Fix typos in comments, reported by scripts/checkpatch.pl using the
> misspelling list in scripts/spelling.txt.  One further misspelling of
> "respectively" in genwqe/card_base.c is fixed as well: it is not in
> scripts/spelling.txt, but it sits a few lines from one that checkpatch
> does report.  Only comments are touched, there are no code changes.
>
> Assisted-by: LLM
> Signed-off-by: Hemanth Selam <hemanth.selam@xxxxxxxxx>

Acked-by: Vishnu Dasa <vishnu.dasa@xxxxxxxxxxxx>

Thanks. vmci changes look good to me.

> ---
>
> Notes (v2):
>     v2:
>      - Drop the drivers/char/lp.c hunk.  It is not under drivers/misc, which
>        is what the "misc:" prefix claimed.  It is now sent separately, as
>        "char: lp: fix typo in comment".
>      - Also fix a second misspelling in genwqe/card_base.c, a few lines from
>        one already being corrected.  checkpatch does not report it because
>        it is not listed in scripts/spelling.txt.
>
>     v1: https://lore.kernel.org/all/20260904113843.21367-1-hemanth.selam@xxxxxxxxx/
>
>  drivers/misc/gehc-achc.c                | 2 +-
>  drivers/misc/genwqe/card_base.c         | 8 ++++----
>  drivers/misc/genwqe/card_ddcb.c         | 4 ++--
>  drivers/misc/genwqe/card_utils.c        | 2 +-
>  drivers/misc/vmw_vmci/vmci_datagram.c   | 2 +-
>  drivers/misc/vmw_vmci/vmci_queue_pair.c | 2 +-
>  6 files changed, 10 insertions(+), 10 deletions(-)
>
> diff --git a/drivers/misc/gehc-achc.c b/drivers/misc/gehc-achc.c
> index 9792189c0923..2c1222edb5dc 100644
> --- a/drivers/misc/gehc-achc.c
> +++ b/drivers/misc/gehc-achc.c
> @@ -369,7 +369,7 @@ static int ezport_firmware_flash_data(struct spi_device *spi,
>         dev_dbg(&spi->dev, "EzPort verify flashed data...\n");
>         ret = ezport_firmware_compare_data(spi, data, size);
>
> -       /* allow missing FW verfication in secure mode */
> +       /* allow missing FW verification in secure mode */
>         if (ret == -EACCES)
>                 ret = 0;
>
> diff --git a/drivers/misc/genwqe/card_base.c b/drivers/misc/genwqe/card_base.c
> index e602eb3c51fa..3eb843af31a5 100644
> --- a/drivers/misc/genwqe/card_base.c
> +++ b/drivers/misc/genwqe/card_base.c
> @@ -286,7 +286,7 @@ int genwqe_flash_readback_fails(struct genwqe_dev *cd)
>   * @cd: GenWQE device information
>   *
>   * Note: From a design perspective it turned out to be a bad idea to
> - * use codes here to specifiy the frequency/speed values. An old
> + * use codes here to specify the frequency/speed values. An old
>   * driver cannot understand new codes and is therefore always a
>   * problem. Better is to measure out the value or put the
>   * speed/frequency directly into a register which is always a valid
> @@ -904,7 +904,7 @@ static int genwqe_reload_bistream(struct genwqe_dev *cd)
>   *
>   * Condition for the health-thread to trigger:
>   *   a) when a kthread_stop() request comes in or
> - *   b) a critical GFIR occured
> + *   b) a critical GFIR occurred
>   *
>   * Informational GFIRs are checked and potentially printed in
>   * GENWQE_HEALTH_CHECK_INTERVAL seconds.
> @@ -1210,10 +1210,10 @@ static int genwqe_probe(struct pci_dev *pci_dev,
>  }
>
>  /**
> - * genwqe_remove() - Called when device is removed (hot-plugable)
> + * genwqe_remove() - Called when device is removed (hot-pluggable)
>   * @pci_dev:   PCI device information struct
>   *
> - * Or when driver is unloaded respecitively when unbind is done.
> + * Or when driver is unloaded respectively when unbind is done.
>   */
>  static void genwqe_remove(struct pci_dev *pci_dev)
>  {
> diff --git a/drivers/misc/genwqe/card_ddcb.c b/drivers/misc/genwqe/card_ddcb.c
> index 969178573940..07e2c1be22d9 100644
> --- a/drivers/misc/genwqe/card_ddcb.c
> +++ b/drivers/misc/genwqe/card_ddcb.c
> @@ -460,7 +460,7 @@ static int genwqe_check_ddcb_queue(struct genwqe_dev *cd,
>  /**
>   * __genwqe_wait_ddcb(): Waits until DDCB is completed
>   * @cd:         pointer to genwqe device descriptor
> - * @req:        pointer to requsted DDCB parameters
> + * @req:        pointer to requested DDCB parameters
>   *
>   * The Service Layer will update the RETC in DDCB when processing is
>   * pending or done.
> @@ -543,7 +543,7 @@ int __genwqe_wait_ddcb(struct genwqe_dev *cd, struct ddcb_requ *req)
>                 return -EINVAL;
>         }
>
> -       /* Severe error occured. Driver is forced to stop operation */
> +       /* Severe error occurred. Driver is forced to stop operation */
>         if (cd->card_state != GENWQE_CARD_USED) {
>                 dev_err(&pci_dev->dev,
>                         "[%s] err: DDCB#%d forced to stop (rc=%d)\n",
> diff --git a/drivers/misc/genwqe/card_utils.c b/drivers/misc/genwqe/card_utils.c
> index e3b5fb337182..7c57cb881d7f 100644
> --- a/drivers/misc/genwqe/card_utils.c
> +++ b/drivers/misc/genwqe/card_utils.c
> @@ -1003,7 +1003,7 @@ u64 genwqe_read_vreg(struct genwqe_dev *cd, u32 reg, int func)
>   * @cd:                genwqe device descriptor
>   *
>   * Note: From a design perspective it turned out to be a bad idea to
> - * use codes here to specifiy the frequency/speed values. An old
> + * use codes here to specify the frequency/speed values. An old
>   * driver cannot understand new codes and is therefore always a
>   * problem. Better is to measure out the value or put the
>   * speed/frequency directly into a register which is always a valid
> diff --git a/drivers/misc/vmw_vmci/vmci_datagram.c b/drivers/misc/vmw_vmci/vmci_datagram.c
> index 6193a22c3ab5..73b43b097f92 100644
> --- a/drivers/misc/vmw_vmci/vmci_datagram.c
> +++ b/drivers/misc/vmw_vmci/vmci_datagram.c
> @@ -434,7 +434,7 @@ EXPORT_SYMBOL_GPL(vmci_datagram_create_handle_priv);
>   * @out_handle: vmci_handle that is populated as a result of this function.
>   *
>   * Creates a host context datagram endpoint and returns a handle to
> - * it.  Same as vmci_datagram_create_handle_priv without the priviledge
> + * it.  Same as vmci_datagram_create_handle_priv without the privilege
>   * flags argument.
>   */
>  int vmci_datagram_create_handle(u32 resource_id,
> diff --git a/drivers/misc/vmw_vmci/vmci_queue_pair.c b/drivers/misc/vmw_vmci/vmci_queue_pair.c
> index 46bba9bef553..e1a11820be01 100644
> --- a/drivers/misc/vmw_vmci/vmci_queue_pair.c
> +++ b/drivers/misc/vmw_vmci/vmci_queue_pair.c
> @@ -2668,7 +2668,7 @@ static ssize_t qp_dequeue_locked(struct vmci_queue *produce_q,
>   * @consume_qsize:      Desired size of the consumer queue.
>   * @peer:       ContextID of the peer.
>   * @flags:      VMCI flags.
> - * @priv_flags: VMCI priviledge flags.
> + * @priv_flags: VMCI privilege flags.
>   *
>   * This is the client interface for allocating the memory for a
>   * vmci_qp structure and then attaching to the underlying
> --
> 2.47.3
>

Attachment: smime.p7s
Description: S/MIME Cryptographic Signature