Den 01-Mar-00 07:02:50 skrev Georgios Kossionis fĝlgende om "Re: Problem: Not configure hde on HPT366 (on ABIT BP6).":
[cut]
> More specifically i used the following values at the lilo prompt:
> 1) LILO: <kernel_name> ide2=0xb000,0xb406 ide3=0xbc00,0xc006
> 2) LILO: <kernel_name> ide2=0xb000,0x0 ide3=0xbc00,0x0
> and 3) LILO: <kernel_name> ide2=0xb000 ide3=0xbc00
[cut]
> At the boot process the following appears with 2 & 3 from the above
> values:
What happens with 1)?
[cut]
> hde: probing with STATUS(0x50) instead of ALTSTATUS(0xff)
> hde: ST328040A, ATA DISK drive
> hdf: probing with STATUS(0x00) instead of ALTSTATUS(0xff)
> hdf: probing with STATUS(0x00) instead of ALTSTATUS(0xff)
> ide2 at 0xb000-0xb007,0xb206 on irq 15
^^^^^^
Odd. It looks as if that ninth port is more or less hard coded to be at
0x0206 after the first one.
Don't you get one more line with something like
hde: ST328040A, 28040 MB w/xxxkB Cache, CHS=xxxxx/xxx/xx
?
> Any further comments or sugestion are valuable.
Well, just two more wild shots:
ide2=0xb400,0x0 ide3=0xc000,0x0
ide2=0xb400,0xb006 ide3=0xc000,0xbc06
Regards,
/ŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻTŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻ\
| Rask Ingemann Lambertsen | E-mail: mailto:rask@kampsax.k-net.dk |
| Registered Phase5 developer | WWW: http://www.gbar.dtu.dk/~c948374/ |
| A4000, 896 kkeys/s (RC5-64) | "ThrustMe" on XPilot, ARCnet and IRC |
| Es funktioniert nicht, sieht aber gut aus. |
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Tue Mar 07 2000 - 21:00:09 EST