Hello, all.
I am using an ABIT BP6 board (SMP, 2 Celerons at 366MHz, none
overclocked, *very* stable) which uses the HPT366 controller. I am getting
through these messages when using the *original* ATA cable (never touched
before) or a replacement one:
hde: dma_intr: status=0x51 { DriveReady SeekComplete Error }
hde: dma_intr: error=0x84 { DriveStatusError BadCRC }
(when the drive first fscks from a dirty reboot)
And, in kernel messages, whilst doing hdparm -tT /dev/hde3:
-> invalidate: busy buffer
(from fs/buffer.c)
(yes, it is wrong to use hde3, but when I use hde, but whatever;
using hda3 or hda did not matter when I used this *same* HDD with normal
IDE cable (not using HPT366))
I am not using *any* special features (untuned HDD), drive was set
to DMA mode 4 at the HPT BIOS.
Any clues on this? I am using kernel 2.4.17, libc 2.2.4, hdparm
4.1.
PS: For now, I'll use this HDD with the normal cables, as I fear
corruption. (yes, the drive runs *perfectly* with the normal cables and
not connected to the HPT366 IDE. It is a Seagate ST310211A HDD.)
Thanks,
Cesar Suga <sartre@linuxbr.com>
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Sat Feb 23 2002 - 21:00:38 EST