I went ahead on a new server and decided to set up a 2.4 kernel. Since
this was going to be a cdimage server I needed what ever HD power I could
get out of it, and more than the standard 8 loop devices. Looking around I
found that I should just be able to pass the 'idebus' and 'max_loop'
parameters to the kernel instead of having to rebuild a kernel.
Unfortunately this is not working. dmesg for ide still shows the following:
ide: Assuming 33MHz system bus speed for PIO modes; override with
idebus=xx
despite the fact that I've specified 'idebus=66' and the following lines note:
VP_IDE: VIA vt82c596b (rev 12) IDE UDMA66 controller on pci00:07.1
and unless I actually pass 'max_loop=255' on an insmod line mounting the
first loop device gives me:
loop: loaded (max 8 devices)
I've tried this w/ the parameters as an append line both globaly and in the
specific kernel stanza I'm loading. I've tried just the idebus parameter
alone since the max_loop parameter isn't as critical on boot (I have other
scripts mounting the 'cds').
Am I doing something wrong here? I just don't see where I've not done what
the docs say.
-- Till Later, Jake- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
This archive was generated by hypermail 2b29 : Sat Aug 31 2002 - 22:00:27 EST