Re: e100 PCI bridge problem

[William Montgomery]

Kok, Auke wrote:

> > 00:1e.0 PCI bridge: Intel Corp. 82801BA/CA/DB/EB/ER Hub interface to 
> > PCI Bridge (rev 82) (prog-if 00 [Normal decode])
> >         Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- 
> > ParErr- Stepping- SERR+ FastB2B-
> >         Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=fast 
> > >TAbort- <TAbort- <MAbort- >SERR- <PERR+
>
>
> PERR+ set... not good - this certainly will cause major issues
I know it sounds that way based on the definition (Detected parity error 
on hub side), however I have two other identical systems that have been 
running fine for months - with this same bit set - only they use an 
Adaptec ANA-64044 (4 port card - 10/100 fast ethernet - unfortunately 
discontinued). 

It seems the Pericom PCI to PCI bridge is having a problem talking to 
the LAN controllers behind the Hint bridge.

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/