Re: [2.6.25.1] qla2xxx can't see more than 4 drives

[Andrew Vasquez]

On Tue, 06 May 2008, Gerhard Mack wrote:

> On Tue, 6 May 2008, Andrew Vasquez wrote:
> > Could you load the driver with the ql2xextended_error_logging module
> > parameter set to 1 and send the resultant driver logs?  Also, it would
> > could you also send the output of the following after the driver is
> > loaded:
> > 
> > $ cat /sys/class/fc_host/host<host_no>
> > $ cat /sys/class/scsi_host/host<host_no>/*
> > $ cat /sys/class/fc_remote_ports/*
> > 
> > where host_no corresponds to the SCSI host-number assigned to the HBA.
> > 
> Of course.. 
> 
> QLogic Fibre Channel HBA Driver
> qla2xxx 0000:02:0a.0: Found an ISP2312, irq 24, iobase 0xf88cc000
> qla2xxx 0000:02:0a.0: Configuring PCI space...
> qla2xxx 0000:02:0a.0: Configure NVRAM parameters...
> qla2xxx 0000:02:0a.0: Verifying loaded RISC code...
> scsi(4): **** Load RISC code ****
...
> cat /sys/class/fc_host/host4/* :
> 0x200000e08b127d20
> 0
> 0x200000e08b127d20
> 0
> 0x000001
> 0x210000e08b127d20
> Online
> LPort (private loop)

Hmm, qla2xxx has a 'split' port-discovery model based on topology.
Switched fabric (P2P) discovery and logins are managed by the driver.
FC_AL topology discovery and logins are managed by firmware.  The
driver (qla2xxx) simply asks the firmware for a list of recognized
ports, as you've noted the driver (and indirectly, firmware), only
recognized 4 ports during LIPA/LIHA/LISA address negotiation:

> cat /sys/class/fc_remote_ports/rport-4\:0-0/*  :
> 0x2200000c507ce546
...
> cat /sys/class/fc_remote_ports/rport-4\:0-1/*
> 0x22000004cf69c688
...
> cat /sys/class/fc_remote_ports/rport-4\:0-2/* | log
> 0x2200000c507ce809
...
> cat /sys/class/fc_remote_ports/rport-4\:0-3/* :
> 0x22000004cf69b98f
...


You mentioned that the 'BIOS' configuration program recognizes 6
devices, have there been any changes made via the BIOS utility to

* assign a hard-loop id?
* acquire a loop-id during LIPA?

or any changes above and beyond 'default' settings?  If so, could you
'retrore' default settings within BIOS utility?

--
Andrew Vasquez
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/