Re: [2.6.25.1] qla2xxx can't see more than 4 drives

[Andrew Vasquez]

On Wed, 07 May 2008, Gerhard Mack wrote:

> > You mentioned that the 'BIOS' configuration program recognizes 6
> > devices, have there been any changes made via the BIOS utility to
> > 
> > * assign a hard-loop id?
> > * acquire a loop-id during LIPA?
> > 
> > or any changes above and beyond 'default' settings?  If so, could you
> > 'retrore' default settings within BIOS utility?
> 
> Hmm your right.. it's only showing 4 drives in the BIOS utility.  Don't 
> know why I recall seeing more ealier.
> 
> It's back to default and only showing 4 drives.

Ok, so at least the BIOS and driver views of the topology are
consistent...  The firmware supports up to 126 devices in a FCAL
topology, so there's no HBA limit that is being run into here.

You mentioned that if you remove the originally visible drives, then
the driver/BIOS can see the previously non-visible drives -- perhaps
there is some limitation with the storage enclosure you are using...

Regards,
Andrew Vasquez
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/