Accelerometer, Gyros and ADC's etc within the kernel.
From: Jonathan Cameron
Date: Tue May 20 2008 - 06:06:15 EST
This email is basically a request for opinions on how and where such sensors
should be integrated into the kernel.
To set the scene...
Increasing numbers of embedded devices are being supplied attached MEMS
devices (www.xbow.com imote2 etc). Along with more traditional sensors such
as ADC's not being used for hardware monitoring, these do not really
seem to
fit with in an particular subsystem of the kernel. A previous
discussion on
lkml in 2006 considered the accelerometers to be found within some laptop
hard drives, but I haven't been able to track down any more general
discussions
of such non hardware monitoring sensors.
The obvious possibilities are:
* To place the various drivers within the spi / i2c etc subsystems as
relevant.
* To place within the hwmon subsystem as this is probably closest.
(there is already at least one straight ADC driver in hwmon)
* To create a new subsystem, or perhaps merely sysfs class to contain these
elements.
Typical requirements within an application include simply polling for
current
readings, and using device triggered interrupts to grab data
continuously to a
ring buffer, for collection by suitable userspace code. Obviously it
would be
desirable to standardize sysfs controls for various calibration
parameters as
much as possible across the various devices.
Any other suggestions welcome!
To illustrate the sort of devices here are a few I have drivers written
for or will
shortly be writing (some submitted to hwmon and spi mailing lists, some
not
finished as of yet)
ST Micro LIS3L02DQ 3D accelerometer. SPI device, no buffering,
interrupt pin
raised high on new data being available. Currently the driver assumes, if
interrupts are enabled, that this is connected to a specified gpio.
(http://www.st.com/stonline/books/pdf/docs/10175.pdf)
VTI SCA3000 E05 3D accelerometer equiped with substantial ring buffer. SPI
device. Can operate either in buffered or direct mode. In buffered
mode, interrupts
can be used to indicate when the ring buffer is 3/4 full triggering a
download to
a larger ring buffer in the kernel if necessary.
(http://www.vti.fi/en/products-solutions/products/accelerometers/sca3000-accelerometers/)
Analog Devices ADIS16350 combined 3D accelerometer and gyro unit. SPI
device.
(http://www.analog.com/en/prod/0,,764_801_ADIS16350%2C00.html)
Maxim MAX1363, MAX1238 ADC's. I2C devices. Some SPI ADC's
(www.analog.com for
examples)
Would be nice if practical to allow the framework to include RS232
devices such
as those from www.xsens.com, www.isense.com and others.
--
Jonathan Cameron
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/