Re: [PATCH] ARM: OMAP: Add support for AM35xx UART4/ttyO3

[Stefano Babic]

On 18/10/2011 20:47, Kyle Manna wrote:
> Add hwmod support to enable access to UART4 of the AM35xx series of
> chips.  The UART4 device referenced from the TRM will show up as ttyO3.
> 
> This was tested on an AM3505.
> 
> Signed-off-by: Kyle Manna <kyle.manna@xxxxxxxxx>
> ---

Hi Kyle,

>  arch/arm/mach-omap2/clock3xxx_data.c       |   11 ++++++
>  arch/arm/mach-omap2/omap_hwmod_3xxx_data.c |   52 ++++++++++++++++++++++++++++
>  arch/arm/mach-omap2/prcm-common.h          |    2 +
>  arch/arm/plat-omap/include/plat/irqs.h     |    2 +-
>  arch/arm/plat-omap/include/plat/serial.h   |    1 +
>  5 files changed, 67 insertions(+), 1 deletions(-)

Can I gently ask you which pinmux setup do you use to test your patch ?

I am trying to make uart4 working on a am3517 with mainline kernel
(3.3+, your patch is merged). However, on my board the uart4 pins are
shared with the camera, and not with SD, as maybe is more common. I set
the pinmux to switch the pins (gpio_95 / gpio_96 / gpio_97 /gpio_98) to
the uart4, and ttyO3 is registered and available, and thanks your patch
both clocks iclk and fclk are active. However, I cannot see activity on
the tx line if I try to send some characters.

Maybe do you use the same pinmux and am I forgetting something else ?

Thanks,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic@xxxxxxx
=====================================================================
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/