[PATCH RFC] media: i2c: mt9p031: add OF support

[Prabhakar Lad]

From: Lad, Prabhakar <prabhakar.csengg@xxxxxxxxx>

add OF support for the mt9p031 sensor driver.

Signed-off-by: Lad, Prabhakar <prabhakar.csengg@xxxxxxxxx>
Cc: Hans Verkuil <hans.verkuil@xxxxxxxxx>
Cc: Laurent Pinchart <laurent.pinchart@xxxxxxxxxxxxxxxx>
Cc: Mauro Carvalho Chehab <mchehab@xxxxxxxxxx>
Cc: Guennadi Liakhovetski <g.liakhovetski@xxxxxx>
Cc: Sylwester Nawrocki <s.nawrocki@xxxxxxxxxxx>
Cc: Sakari Ailus <sakari.ailus@xxxxxx>
Cc: Grant Likely <grant.likely@xxxxxxxxxxxx>
Cc: Rob Herring <rob.herring@xxxxxxxxxxx>
Cc: Rob Landley <rob@xxxxxxxxxxx>
Cc: devicetree-discuss@xxxxxxxxxxxxxxxx
Cc: linux-doc@xxxxxxxxxxxxxxx
Cc: linux-kernel@xxxxxxxxxxxxxxx
---
 .../devicetree/bindings/media/i2c/mt9p031.txt      |   43 ++++++++++++++
 drivers/media/i2c/mt9p031.c                        |   61 +++++++++++++++++++-
 2 files changed, 103 insertions(+), 1 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/media/i2c/mt9p031.txt

diff --git a/Documentation/devicetree/bindings/media/i2c/mt9p031.txt b/Documentation/devicetree/bindings/media/i2c/mt9p031.txt
new file mode 100644
index 0000000..b985e63
--- /dev/null
+++ b/Documentation/devicetree/bindings/media/i2c/mt9p031.txt
@@ -0,0 +1,43 @@
+* Aptina 1/2.5-Inch 5Mp CMOS Digital Image Sensor
+
+The Aptina MT9P031 is a 1/2.5-inch CMOS active pixel digital image sensor with
+an active imaging pixel array of 2592H x 1944V. It incorporates sophisticated
+camera functions on-chip such as windowing, column and row skip mode, and
+snapshot mode. It is programmable through a simple two-wire serial interface.
+
+The MT9P031 is a progressive-scan sensor that generates a stream of pixel data
+at a constant frame rate. It uses an on-chip, phase-locked loop (PLL) to
+generate all internal clocks from a single master input clock running between 6
+and 27 MHz. The maximum pixel rate is 96 Mp/s, corresponding to a clock rate of
+96 MHz.
+
+Required Properties :
+- compatible : value should be either one among the following
+	(a) "aptina,mt9p031-sensor" for mt9p031 sensor
+	(b) "aptina,mt9p031m-sensor" for mt9p031m sensor
+
+- ext_freq: Input clock frequency.
+
+- target_freq:  Pixel clock frequency.
+
+Optional Properties :
+-reset: Chip reset GPIO (If not specified defaults to -1)
+
+Example:
+
+i2c0@1c22000 {
+	...
+	...
+	mt9p031@5d {
+		compatible = "aptina,mt9p031-sensor";
+		reg = <0x5d>;
+
+		port {
+			mt9p031_1: endpoint {
+				ext_freq = <6000000>;
+				target_freq = <96000000>;
+			};
+		};
+	};
+	...
+};
\ No newline at end of file
diff --git a/drivers/media/i2c/mt9p031.c b/drivers/media/i2c/mt9p031.c
index 28cf95b..66078a6 100644
--- a/drivers/media/i2c/mt9p031.c
+++ b/drivers/media/i2c/mt9p031.c
@@ -23,11 +23,13 @@
 #include <linux/regulator/consumer.h>
 #include <linux/slab.h>
 #include <linux/videodev2.h>
+#include <linux/of_device.h>
 
 #include <media/mt9p031.h>
 #include <media/v4l2-chip-ident.h>
 #include <media/v4l2-ctrls.h>
 #include <media/v4l2-device.h>
+#include <media/v4l2-of.h>
 #include <media/v4l2-subdev.h>
 
 #include "aptina-pll.h"
@@ -928,10 +930,66 @@ static const struct v4l2_subdev_internal_ops mt9p031_subdev_internal_ops = {
  * Driver initialization and probing
  */
 
+#if defined(CONFIG_OF)
+static const struct of_device_id mt9p031_of_match[] = {
+	{.compatible = "aptina,mt9p031-sensor", },
+	{.compatible = "aptina,mt9p031m-sensor", },
+	{},
+};
+MODULE_DEVICE_TABLE(of, mt9p031_of_match);
+
+static struct mt9p031_platform_data
+	*mt9p031_get_pdata(struct i2c_client *client)
+
+{
+	if (!client->dev.platform_data && client->dev.of_node) {
+		struct device_node *np;
+		struct mt9p031_platform_data *pdata;
+		int ret;
+
+		np = v4l2_of_get_next_endpoint(client->dev.of_node, NULL);
+		if (!np)
+			return NULL;
+
+		pdata = devm_kzalloc(&client->dev,
+				     sizeof(struct mt9p031_platform_data),
+				     GFP_KERNEL);
+		if (!pdata) {
+			pr_warn("mt9p031 failed allocate memeory\n");
+			return NULL;
+		}
+		ret = of_property_read_u32(np, "reset", &pdata->reset);
+		if (ret == -EINVAL)
+			pdata->reset = -1;
+		else if (ret == -ENODATA)
+			return NULL;
+
+		if (of_property_read_u32(np, "ext_freq", &pdata->ext_freq))
+			return NULL;
+
+		if (of_property_read_u32(np, "target_freq",
+					 &pdata->target_freq))
+			return NULL;
+
+		return pdata;
+	}
+
+	return NULL;
+}
+#else
+#define mt9p031_of_match NULL
+
+static struct mt9p031_platform_data
+	*mt9p031_get_pdata(struct i2c_client *client)
+{
+	return client->dev.platform_data;
+}
+#endif
+
 static int mt9p031_probe(struct i2c_client *client,
 			 const struct i2c_device_id *did)
 {
-	struct mt9p031_platform_data *pdata = client->dev.platform_data;
+	struct mt9p031_platform_data *pdata = mt9p031_get_pdata(client);
 	struct i2c_adapter *adapter = to_i2c_adapter(client->dev.parent);
 	struct mt9p031 *mt9p031;
 	unsigned int i;
@@ -1072,6 +1130,7 @@ MODULE_DEVICE_TABLE(i2c, mt9p031_id);
 
 static struct i2c_driver mt9p031_i2c_driver = {
 	.driver = {
+		.of_match_table = mt9p031_of_match,
 		.name = "mt9p031",
 	},
 	.probe          = mt9p031_probe,
-- 
1.7.4.1

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/