RE: [PATCH v3] regulator: pfuze100: add pfuze100 regulator driver

[Gong Yibin-B38343]

Thanks Mark, I will send V4. 

-----Original Message-----
From: Mark Brown [mailto:broonie@xxxxxxxxxx] 
Sent: Saturday, July 20, 2013 1:31 AM
To: Gong Yibin-B38343
Cc: grant.likely@xxxxxxxxxx; rob.herring@xxxxxxxxxxx; rob@xxxxxxxxxxx; lgirdwood@xxxxxxxxx; shawn.guo@xxxxxxxxxx; devicetree-discuss@xxxxxxxxxxxxxxxx; linux-doc@xxxxxxxxxxxxxxx; linux-kernel@xxxxxxxxxxxxxxx
Subject: Re: [PATCH v3] regulator: pfuze100: add pfuze100 regulator driver

On Fri, Jul 19, 2013 at 06:14:51PM +0800, Robin Gong wrote:

> Add pfuze100 regulator driver.

Looks good, there's some minor issues below but they should be small.

> --- a/drivers/regulator/Kconfig
> +++ b/drivers/regulator/Kconfig
> @@ -158,6 +158,13 @@ config REGULATOR_MC13892
>  	  Say y here to support the regulators found on the Freescale MC13892
>  	  PMIC.
>  
> +config REGULATOR_PFUZE100
> +	tristate "Support regulators on Freescale PFUZE100 PMIC"
> +	depends on I2C
> +	help
> +	  Say y here to support the regulators found on the Freescale PFUZE100
> +	  PMIC.
> +

Please keep this and the Makefile sorted - if there's issues merging then please use my topic/kconfig as a base.

> +		if (val & 0x40)
> +			ramp_delay = 50000 / (4 * ramp_delay);
> +		else
> +			ramp_delay = 25000 / (2 * ramp_delay);
> +		if (id <= PFUZE100_SW1C)
> +			ramp_delay = 25000 / (2 * ramp_delay);

This is a bit confusing as there's a cumalaitve modification applied to ramp_delay in the case that id is less than SW1C but it's not obvious that this is intentional given the calculations.  Please change this to make it clearer what the intended logic is (assuming it's not buggy) - something like if ... else if ... else for example.

> +	ret = regmap_read(pfuze_chip->regmap, PFUZE100_REVID, &value);
> +	if (ret)
> +		return ret;
> +	dev_info(pfuze_chip->dev,
> +		 "Full lay: %x ,Metal lay: %x\n",
> +		 (value & 0xf0) >> 4, value & 0x0f);

The space should be after not before the comma in the displayed string.

> +	dev_info(pfuze_chip->dev, "FAB: %x , FIN: %x\n",
> +		 (value & 0xc) >> 2, value & 0x3);

Only a space after the , for normal formatting.  ie both should look like "%x, bar".

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/