On 08/28/2013 04:01 AM, Oleksandr Kravchenko wrote:Feel free to add the relevant lines in the patch that adds the attribute. We should not add stuff here that is not used.Add description about in_accelX_power_mode andShall we add power_mode to all sensors not just accelerometer? HID
in_accel_power_mode_available.
Signed-off-by: Oleksandr Kravchenko <o.v.kravchenko@xxxxxxxxxxxxxxx>
---
Documentation/ABI/testing/sysfs-bus-iio | 10 ++++++++++
1 file changed, 10 insertions(+)
diff --git a/Documentation/ABI/testing/sysfs-bus-iio
b/Documentation/ABI/testing/sysfs-bus-iio
index dda81ff..1a333f3 100644
--- a/Documentation/ABI/testing/sysfs-bus-iio
+++ b/Documentation/ABI/testing/sysfs-bus-iio
@@ -792,3 +792,13 @@ Contact: linux-iio@xxxxxxxxxxxxxxx
Description:
This attribute is used to read the amount of quadrature error
present in the device at a given time.
+
+What: /sys/.../iio:deviceX/in_accelX_power_mode
sensor hub spec allows every sensor in it to go low power mode.
This is not same as OFF.
+KernelVersion: 3.11
+Contact: linux-iio@xxxxxxxxxxxxxxx
+Description:
+ Specifies the chip power mode.
+ low_noise: reduce noise level from ADC,
+ low_power: enable low current consumption.
+ For a list of available output power modes read
+ in_accel_power_mode_available.
--
To unsubscribe from this list: send the line "unsubscribe linux-iio" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html