Re: [PATCH RESEND 2/5] pinctrl: berlin: add a pinctrl driver for Marvell Berlin SoCs

From: Antoine Ténart
Date: Tue Apr 22 2014 - 11:57:12 EST


Linus,

On Tue, Apr 22, 2014 at 02:52:10PM +0200, Linus Walleij wrote:
> On Fri, Apr 11, 2014 at 3:35 PM, Sebastian Hesselbarth
> <sebastian.hesselbarth@xxxxxxxxx> wrote:
> > On 04/11/2014 02:37 PM, Antoine Ténart wrote:
> >> On Fri, Apr 11, 2014 at 11:03:48AM +0200, Sebastian Hesselbarth wrote:
> >>> On 04/10/2014 03:07 PM, Antoine Ténart wrote:
>
> >>> Having said that, the above assumes that each function is unique
> >>> but IIRC the idea of the function table was to group pins/groups
> >>> with the same function, e.g. function "gpio", groups 1,7,25,...
> >>
> >> Most of the functions you can use on the Berlin they will be unique and
> >> would
> >> only be used in one group, except for the 'gpio' one.
> >
> > Yeah, I had a similar discussion about it back then for mvebu. IIRC, the
> > correct answer is: Have a list of functions with groups assigned to it
> > no matter if there is only one group per function (or 40 per function as
> > it will be for gpio).
> >
> > Maybe Linus can give an update on how to deal with it?
>
> Have you considered implementing pinmux_ops
> .gpio_request_enable(), .gpio_set_direction() and
> .gpio_disable_free() instead of defining groups for each
> and every GPIO?

The function 'gpio' can be found on different groups. But the Berlin pin muxing
does not allow to configure a pin individually. It is then not possible to mux
GPIO pins individually. For example the 'gpio' function of group 'GSM2' on the
BG2Q will mux GPIOs 17 *and* 18.

Groups does not have more than a single 'gpio' function.

Since the gpio_request_enable() comment says 'Implement this only if you can mux
every pin individually as GPIO', I did not considered implementing these
functions.

Antoine

--
Antoine Ténart, Free Electrons
Embedded Linux, Kernel and Android engineering
http://free-electrons.com
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/