[PATCH 1/1] PINCTRL: Warn if direct IRQ GPIO set to output

[eric . ernst]

From: Eric Ernst <eric.ernst@xxxxxxxxxxxxxxx>

For Baytrail, you should never set a GPIO set to direct_irq
to output mode.  When direct_irq_en is set for a GPIO, it is
tied directly to an APIC internally, and making the pad output
does not make any sense. Assert a WARN() in the event this happens.

Signed-off-by: Eric Ernst <eric.ernst@xxxxxxxxxxxxxxx>
---
 drivers/pinctrl/pinctrl-baytrail.c |   16 ++++++++++++----
 1 file changed, 12 insertions(+), 4 deletions(-)

diff --git a/drivers/pinctrl/pinctrl-baytrail.c b/drivers/pinctrl/pinctrl-baytrail.c
index e59983423991..677f79a9efca 100644
--- a/drivers/pinctrl/pinctrl-baytrail.c
+++ b/drivers/pinctrl/pinctrl-baytrail.c
@@ -47,6 +47,7 @@
 #define BYT_TRIG_POS		BIT(25)
 #define BYT_TRIG_LVL		BIT(24)
 #define BYT_PIN_MUX		0x07
+#define BYT_DIRECTIRQ		BIT(27)
 
 /* BYT_VAL_REG register bits */
 #define BYT_INPUT_EN		BIT(2)  /* 0: input enabled (active low)*/
@@ -256,19 +257,26 @@ static int byt_gpio_direction_output(struct gpio_chip *chip,
 				     unsigned gpio, int value)
 {
 	struct byt_gpio *vg = to_byt_gpio(chip);
-	void __iomem *reg = byt_gpio_reg(chip, gpio, BYT_VAL_REG);
+	void __iomem *conf_reg = byt_gpio_reg(chip, gpio, BYT_CONF0_REG);
+	void __iomem *value_reg = byt_gpio_reg(chip, gpio, BYT_VAL_REG);
 	unsigned long flags;
 	u32 reg_val;
 
 	spin_lock_irqsave(&vg->lock, flags);
 
-	reg_val = readl(reg) | BYT_DIR_MASK;
+	/* Before making any direction modifications, do a check if gpio
+	is set for direct IRQ.  On baytrail, setting GPIO to output does
+	not make sense, so let's at least warn the caller before they shoot
+	themselves in the foot */
+	WARN((readl(conf_reg) & BYT_DIRECTIRQ), "Potential Error: Setting GPIO with direct_irq_en to output");
+
+	reg_val = readl(value_reg) | BYT_DIR_MASK;
 	reg_val &= ~BYT_OUTPUT_EN;
 
 	if (value)
-		writel(reg_val | BYT_LEVEL, reg);
+		writel(reg_val | BYT_LEVEL, value_reg);
 	else
-		writel(reg_val & ~BYT_LEVEL, reg);
+		writel(reg_val & ~BYT_LEVEL, value_reg);
 
 	spin_unlock_irqrestore(&vg->lock, flags);
 
-- 
1.7.9.5

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/