Re: [PATCH v3 05/11] memory: add Atmel EBI (External Bus Interface) driver

[Arnd Bergmann]

On Monday 01 December 2014 19:29:23 Boris Brezillon wrote:
> Hi Arnd,
> 
> On Mon, 01 Dec 2014 17:26:27 +0100
> Arnd Bergmann <arnd@xxxxxxxx> wrote:
> 
> > On Monday 01 December 2014 11:27:21 Boris Brezillon wrote:
> > > The EBI (External Bus Interface) is used to access external peripherals
> > > (NOR, SRAM, NAND, and other specific devices like ethernet controllers).
> > > Each device is assigned a CS line and an address range and can have its
> > > own configuration (timings, access mode, bus width, ...).
> > > This driver provides a generic DT binding to configure a device according
> > > to its requirements.
> > > For specific device controllers (like the NAND one) the SMC timings
> > > should be configured by the controller driver through the matrix and
> > > smc syscon regmaps.
> > 
> > Nice!
> > 
> > > +
> > > +#define AT91_EBICSA_REGFIELD(soc)			\
> > > +	REG_FIELD(soc ## _MATRIX_EBICSA_OFF, 0,		\
> > > +		  AT91_MATRIX_EBI_NUM_CS - 1)
> > > +
> > > +#define AT91_MULTI_EBICSA_REGFIELD(soc, n)		\
> > > +	REG_FIELD(soc ## _MATRIX_EBI ## n ## CSA_OFF,	\
> > > +		  0, AT91_MATRIX_EBI_NUM_CS - 1)
> > 
> > I don't like the use macros that concatenate symbol names like
> > this. Why not do either
> > 
> > - open-code the macro contents in the few uses, to allow
> >   grepping for them, or
> 
> I'm not sure to get this one, are you suggesting to do something like
> this:
> 
> #define AT91_EBICSA_REGFIELD(off)			\
> 	REG_FIELD(ebicsa_off, AT91_MATRIX_EBI_NUM_CS - 1)
> 

That would be acceptable too, but what I really meant is one step further:

static const struct reg_field at91sam9260_ebi_csa = 
	REG_FIELD(AT91SAM9260_MATRIX_EBICSA_OFF, 0, AT91_MATRIX_EBI_NUM_CS - 1);

> > - put the register number in the syscon reference and look it
> >   up from there (this would be slightly more complicated for the
> >   second macro)
> 
> I've told several times not to encode register offsets or register ids
> in the DT :-) (and if I'm not mistaken that's what you're suggesting
> here).

I think it's actually fine for syscon references, although in general
I would agree with that. The difference in my opinion is that syscon
by nature is a set of registers.

	Arnd
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/