Re: [PATCH RFC v4 net-next 0/5] virtio_net: enabling tx interrupts
From: Michael S. Tsirkin
Date: Tue Dec 02 2014 - 04:43:35 EST
On Tue, Dec 02, 2014 at 08:15:02AM +0008, Jason Wang wrote:
>
>
> On Tue, Dec 2, 2014 at 11:15 AM, Jason Wang <jasowang@xxxxxxxxxx> wrote:
> >
> >
> >On Mon, Dec 1, 2014 at 6:42 PM, Michael S. Tsirkin <mst@xxxxxxxxxx> wrote:
> >>On Mon, Dec 01, 2014 at 06:17:03PM +0800, Jason Wang wrote:
> >>> Hello:
> >>> We used to orphan packets before transmission for virtio-net. This
> >>>breaks
> >>> socket accounting and can lead serveral functions won't work, e.g:
> >>> - Byte Queue Limit depends on tx completion nofication to work.
> >>> - Packet Generator depends on tx completion nofication for the last
> >>> transmitted packet to complete.
> >>> - TCP Small Queue depends on proper accounting of sk_wmem_alloc to
> >>>work.
> >>> This series tries to solve the issue by enabling tx interrupts. To
> >>>minize
> >>> the performance impacts of this, several optimizations were used:
> >>> - In guest side, virtqueue_enable_cb_delayed() was used to delay the
> >>>tx
> >>> interrupt untile 3/4 pending packets were sent.
> >>> - In host side, interrupt coalescing were used to reduce tx
> >>>interrupts.
> >>> Performance test results[1] (tx-frames 16 tx-usecs 16) shows:
> >>> - For guest receiving. No obvious regression on throughput were
> >>> noticed. More cpu utilization were noticed in few cases.
> >>> - For guest transmission. Very huge improvement on througput for
> >>>small
> >>> packet transmission were noticed. This is expected since TSQ and
> >>>other
> >>> optimization for small packet transmission work after tx interrupt.
> >>>But
> >>> will use more cpu for large packets.
> >>> - For TCP_RR, regression (10% on transaction rate and cpu
> >>>utilization) were
> >>> found. Tx interrupt won't help but cause overhead in this case.
> >>>Using
> >>> more aggressive coalescing parameters may help to reduce the
> >>>regression.
> >>
> >>OK, you do have posted coalescing patches - does it help any?
> >
> >Helps a lot.
> >
> >For RX, it saves about 5% - 10% cpu. (reduce 60%-90% tx intrs)
> >For small packet TX, it increases 33% - 245% throughput. (reduce about 60%
> >inters)
> >For TCP_RR, it increase the 3%-10% trans.rate. (reduce 40%-80% tx intrs)
> >
> >>
> >>I'm not sure the regression is due to interrupts.
> >>It would make sense for CPU but why would it
> >>hurt transaction rate?
> >
> >Anyway guest need to take some cycles to handle tx interrupts.
> >And transaction rate does increase if we coalesces more tx interurpts.
> >>
> >>
> >>It's possible that we are deferring kicks too much due to BQL.
> >>
> >>As an experiment: do we get any of it back if we do
> >>- if (kick || netif_xmit_stopped(txq))
> >>- virtqueue_kick(sq->vq);
> >>+ virtqueue_kick(sq->vq);
> >>?
> >
> >
> >I will try, but during TCP_RR, at most 1 packets were pending,
> >I suspect if BQL can help in this case.
>
> Looks like this helps a lot in multiple sessions of TCP_RR.
so what's faster
BQL + kick each packet
no BQL
?
> How about move the BQL patch out of this series?
>
> Let's first converge tx interrupt and then introduce it?
> (e.g with kicking after queuing X bytes?)
Sounds good.
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/