Re: [PATCH 3/5] ASoC: dwc: Iterate over all channels

From: rajeev kumar
Date: Thu Dec 04 2014 - 01:55:35 EST


On Wed, Dec 3, 2014 at 10:59 PM, Mark Brown <broonie@xxxxxxxxxx> wrote:
> On Wed, Dec 03, 2014 at 04:39:01PM +0000, Andrew Jackson wrote:
>
>> + /* Iterate over set of channels - independently controlled.
>> + */
>> + do {
>> + if (substream->stream == SNDRV_PCM_STREAM_PLAYBACK) {
>> + i2s_write_reg(dev->i2s_base, TCR(ch_reg),
>> + xfer_resolution);
>> + i2s_write_reg(dev->i2s_base, TFCR(ch_reg), 0x02);
>> + irq = i2s_read_reg(dev->i2s_base, IMR(ch_reg));
>> + i2s_write_reg(dev->i2s_base, IMR(ch_reg), irq & ~0x30);
>> + i2s_write_reg(dev->i2s_base, TER(ch_reg), 1);
>> + } else {
>> + i2s_write_reg(dev->i2s_base, RCR(ch_reg),
>> + xfer_resolution);
>> + i2s_write_reg(dev->i2s_base, RFCR(ch_reg), 0x07);
>> + irq = i2s_read_reg(dev->i2s_base, IMR(ch_reg));
>> + i2s_write_reg(dev->i2s_base, IMR(ch_reg), irq & ~0x03);
>> + i2s_write_reg(dev->i2s_base, RER(ch_reg), 1);
>> + }
>> + } while (ch_reg-- > 0);
>
> The normal way to write an iteration would be with a for loop - why are
> we not doing that?
>
> Also I see that you've not sent these as a single thread - please use
> --thread.

designware i2s has individual register for channel support. It is like
TCR(0), TCR(1) and so on.. So a macro is defined to capture these
please check below #define

#define TCR(x) (0x40 * x + 0x034)

and the same is true for capture also. So there is no need for
iteration. Only writing to the particular register will do the work.

~Rajeev
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/