[PATCH 4/4] ARM: at91/dt: sama5: move NAND nodes into board dts/dtsi
From: Boris Brezillon
Date: Thu Dec 04 2014 - 17:30:42 EST
sama5d3 and sama5d4 SoCs provides several CS to interface with external
memories, and in particular NAND chips.
The NAND flash controller embedded in the these SoCs can connect to any of
the available CS (each CS is assigned a memory range, hence the nand@xxx
you're seeing in the DT), thus the NAND chip definition should be part of
the board description because we cannot guess at the SoC level which CS
will be chosen by the board designer.
Signed-off-by: Boris Brezillon <boris.brezillon@xxxxxxxxxxxxxxxxxx>
---
arch/arm/boot/dts/at91-sama5d3_xplained.dts | 18 +++++++++++++++++-
arch/arm/boot/dts/at91-sama5d4ek.dts | 16 +++++++++++++++-
arch/arm/boot/dts/sama5d3.dtsi | 21 ---------------------
arch/arm/boot/dts/sama5d3xcm.dtsi | 18 +++++++++++++++++-
arch/arm/boot/dts/sama5d4.dtsi | 19 -------------------
5 files changed, 49 insertions(+), 43 deletions(-)
diff --git a/arch/arm/boot/dts/at91-sama5d3_xplained.dts b/arch/arm/boot/dts/at91-sama5d3_xplained.dts
index fec1fca..860258b 100644
--- a/arch/arm/boot/dts/at91-sama5d3_xplained.dts
+++ b/arch/arm/boot/dts/at91-sama5d3_xplained.dts
@@ -213,13 +213,29 @@
};
nand0: nand@60000000 {
+ compatible = "atmel,at91rm9200-nand";
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges;
+ reg = < 0x60000000 0x01000000 /* EBI CS3 */
+ 0xffffc070 0x00000490 /* SMC PMECC regs */
+ 0xffffc500 0x00000100 /* SMC PMECC Error Location regs */
+ 0x00110000 0x00018000 /* ROM code */
+ >;
+ interrupts = <5 IRQ_TYPE_LEVEL_HIGH 6>;
+ atmel,nand-addr-offset = <21>;
+ atmel,nand-cmd-offset = <22>;
+ atmel,nand-has-dma;
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_nand0_ale_cle>;
+ atmel,pmecc-lookup-table-offset = <0x0 0x8000>;
+ atmel,nfc = <&nfc>;
nand-bus-width = <8>;
nand-ecc-mode = "hw";
atmel,has-pmecc;
atmel,pmecc-cap = <4>;
atmel,pmecc-sector-size = <512>;
nand-on-flash-bbt;
- status = "okay";
at91bootstrap@0 {
label = "at91bootstrap";
diff --git a/arch/arm/boot/dts/at91-sama5d4ek.dts b/arch/arm/boot/dts/at91-sama5d4ek.dts
index b5b8400..5de0d2d 100644
--- a/arch/arm/boot/dts/at91-sama5d4ek.dts
+++ b/arch/arm/boot/dts/at91-sama5d4ek.dts
@@ -204,11 +204,25 @@
};
nand0: nand@80000000 {
+ compatible = "atmel,at91rm9200-nand";
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges;
+ reg = < 0x80000000 0x08000000 /* EBI CS3 */
+ 0xfc05c070 0x00000490 /* SMC PMECC regs */
+ 0xfc05c500 0x00000100 /* SMC PMECC Error Location regs */
+ >;
+ interrupts = <22 IRQ_TYPE_LEVEL_HIGH 6>;
+ atmel,nand-addr-offset = <21>;
+ atmel,nand-cmd-offset = <22>;
+ atmel,nand-has-dma;
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_nand>;
+ atmel,nfc = <&nfc>;
nand-bus-width = <8>;
nand-ecc-mode = "hw";
nand-on-flash-bbt;
atmel,has-pmecc;
- status = "okay";
at91bootstrap@0 {
label = "at91bootstrap";
diff --git a/arch/arm/boot/dts/sama5d3.dtsi b/arch/arm/boot/dts/sama5d3.dtsi
index 1749853..0a944e0 100644
--- a/arch/arm/boot/dts/sama5d3.dtsi
+++ b/arch/arm/boot/dts/sama5d3.dtsi
@@ -1397,27 +1397,6 @@
status = "disabled";
};
- nand0: nand@60000000 {
- compatible = "atmel,at91rm9200-nand";
- #address-cells = <1>;
- #size-cells = <1>;
- ranges;
- reg = < 0x60000000 0x01000000 /* EBI CS3 */
- 0xffffc070 0x00000490 /* SMC PMECC regs */
- 0xffffc500 0x00000100 /* SMC PMECC Error Location regs */
- 0x00110000 0x00018000 /* ROM code */
- >;
- interrupts = <5 IRQ_TYPE_LEVEL_HIGH 6>;
- atmel,nand-addr-offset = <21>;
- atmel,nand-cmd-offset = <22>;
- atmel,nand-has-dma;
- pinctrl-names = "default";
- pinctrl-0 = <&pinctrl_nand0_ale_cle>;
- atmel,pmecc-lookup-table-offset = <0x0 0x8000>;
- atmel,nfc = <&nfc>;
- status = "disabled";
- };
-
nfc: nfc@70000000 {
compatible = "atmel,sama5d3-nfc";
reg = <0x70000000 0x10000000 /* NFC Command Registers */
diff --git a/arch/arm/boot/dts/sama5d3xcm.dtsi b/arch/arm/boot/dts/sama5d3xcm.dtsi
index cfcd200..e6c2aec 100644
--- a/arch/arm/boot/dts/sama5d3xcm.dtsi
+++ b/arch/arm/boot/dts/sama5d3xcm.dtsi
@@ -76,13 +76,29 @@
};
nand0: nand@60000000 {
+ compatible = "atmel,at91rm9200-nand";
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges;
+ reg = < 0x60000000 0x01000000 /* EBI CS3 */
+ 0xffffc070 0x00000490 /* SMC PMECC regs */
+ 0xffffc500 0x00000100 /* SMC PMECC Error Location regs */
+ 0x00110000 0x00018000 /* ROM code */
+ >;
+ interrupts = <5 IRQ_TYPE_LEVEL_HIGH 6>;
+ atmel,nand-addr-offset = <21>;
+ atmel,nand-cmd-offset = <22>;
+ atmel,nand-has-dma;
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_nand0_ale_cle>;
+ atmel,pmecc-lookup-table-offset = <0x0 0x8000>;
+ atmel,nfc = <&nfc>;
nand-bus-width = <8>;
nand-ecc-mode = "hw";
atmel,has-pmecc;
atmel,pmecc-cap = <4>;
atmel,pmecc-sector-size = <512>;
nand-on-flash-bbt;
- status = "okay";
at91bootstrap@0 {
label = "at91bootstrap";
diff --git a/arch/arm/boot/dts/sama5d4.dtsi b/arch/arm/boot/dts/sama5d4.dtsi
index 3b5e9f1..8647eb3 100644
--- a/arch/arm/boot/dts/sama5d4.dtsi
+++ b/arch/arm/boot/dts/sama5d4.dtsi
@@ -265,25 +265,6 @@
cache-level = <2>;
};
- nand0: nand@80000000 {
- compatible = "atmel,at91rm9200-nand";
- #address-cells = <1>;
- #size-cells = <1>;
- ranges;
- reg = < 0x80000000 0x08000000 /* EBI CS3 */
- 0xfc05c070 0x00000490 /* SMC PMECC regs */
- 0xfc05c500 0x00000100 /* SMC PMECC Error Location regs */
- >;
- interrupts = <22 IRQ_TYPE_LEVEL_HIGH 6>;
- atmel,nand-addr-offset = <21>;
- atmel,nand-cmd-offset = <22>;
- atmel,nand-has-dma;
- pinctrl-names = "default";
- pinctrl-0 = <&pinctrl_nand>;
- atmel,nfc = <&nfc>;
- status = "disabled";
- };
-
nfc: nfc@90000000 {
compatible = "atmel,sama5d3-nfc";
reg = <0x90000000 0x10000000 /* NFC Command Registers */
--
1.9.1
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/