Re: [linux-sunxi] Re: [RFC 7/7] ARM: dts: sun9i: Add secure SRAM node used for MCPM SMP hotplug

[Chen-Yu Tsai]

On Tue, May 26, 2015 at 5:24 AM, Maxime Ripard
<maxime.ripard@xxxxxxxxxxxxxxxxxx> wrote:
> On Sun, May 24, 2015 at 11:55:22PM +0800, Chen-Yu Tsai wrote:
>> On Wed, May 20, 2015 at 6:08 PM, Maxime Ripard
>> <maxime.ripard@xxxxxxxxxxxxxxxxxx> wrote:
>> > On Thu, May 14, 2015 at 02:10:11PM +0800, Chen-Yu Tsai wrote:
>> >> The A80 stores some magic flags in a portion of the secure SRAM. The
>> >> BROM jumps directly to the software entry point set by the SMP code
>> >> if the flags are set. This is required for CPU0 hotplugging.
>> >>
>> >> Signed-off-by: Chen-Yu Tsai <wens@xxxxxxxx>
>> >> ---
>> >>  arch/arm/boot/dts/sun9i-a80.dtsi | 20 ++++++++++++++++++++
>> >>  1 file changed, 20 insertions(+)
>> >>
>> >> diff --git a/arch/arm/boot/dts/sun9i-a80.dtsi b/arch/arm/boot/dts/sun9i-a80.dtsi
>> >> index 1507bd2a88f0..0695215634d4 100644
>> >> --- a/arch/arm/boot/dts/sun9i-a80.dtsi
>> >> +++ b/arch/arm/boot/dts/sun9i-a80.dtsi
>> >> @@ -366,6 +366,26 @@
>> >>                */
>> >>               ranges = <0 0 0 0x20000000>;
>> >>
>> >> +             sram_b: sram@00020000 {
>> >> +                     /* 256 KiB secure SRAM at 0x20000 */
>> >> +                     compatible = "mmio-sram";
>> >> +                     reg = <0x00020000 0x40000>;
>> >> +
>> >
>> > We should probably add a property to that SRAM to tell the driver not
>> > to access it if we're not booted in secure mode.
>>
>> (CC-ing Heiko...)
>>
>> That kind of puts architecture (ARM) dependent code into a platform
>> driver. Furthermore, AFAIK there isn't a safe way to check if we're
>> in secure mode or not. Checking SCR raises an undefined instruction
>> exception in non-secure mode. Can the kernel handle that? I really
>> don't understand this bit well.
>
> That's a very good question. I'm pretty sure the kernel can know that,
> since it actually prints the execution mode, and must be able to know
> whether it can use the virtualization extensions or not I assume.

What you are referring to is HYP vs SVC mode. IIUC, this is not the
same as secure vs non-secure. The kernel can be booted into non-secure
SVC mode. Just disable CONFIG_CPU_V7_HAS_VIRT on mainline u-boot for
sun7i, and you get a system booted in non-secure mode. The architected
timer's non-secure interrupt firing is proof.

Which brings us back to my original question. Is there a way the kernel
can reliably detect whether it is in secure mode or not?

>> > Otherwise, bad things might happen.
>>
>> The kernel (or rather the bootloader) boots in secure mode by default,
>> and we don't have any bootloader support to boot into non-secure mode
>> ATM.
>
> That's not really true. We do have some U-Boot patches, and U-Boot
> might very well be setup to boot into HYP, even though it doesn't do
> anything else.

Same thing can be done for sun6i/sun8i. I should probably test this
and see if it has any impact on the current SMP bring-up.

> And even so, the fact that we have no implementation yet doesn't mean
> that we won't have one in a few month. So just sweeping it under the
> carpet doesn't seem to be a very good solution.
>
>> Couldn't we have the bootloader mark the SRAM as disabled when
>> booting into non-secure when we add that support?
>
> It actually changes the kernel requirements to be able to
> boot. Changing that is not an option, especially since it's something
> that: 1) isn't dynamic in any way, 2) will possibly break the kernel
> if not done, 3) require synchronisation between the bootloader and the
> kernel when a new secure SRAM is added to the DT, and require an
> upgrade of the bootloader, 4) we might not be able to replace the
> bootloader in the first place.
>
> All of these issues make it look like a rather bad solution :/

I think the discussions here depends on the question I asked earlier.
If the bootloader left the kernel in non-secure without any way to
signal this fact, then SMP probably won't work either.

Looking at the diagram on page 291 of the user manual, many critical
hardware blocks are marked as trusted (probably secure?), I don't
think we can boot Linux non-secure with the same DT...


Regards
ChenYu
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/