[PATCH v2 3/4] spi: mediatek: use BIT() to instead of SPI_CMD_*_OFFSET

From: Leilk Liu
Date: Thu Aug 20 2015 - 05:20:29 EST


This patch removes SPI_CMD_*_OFFSET defines, and uses the BIT(x)
defines instead.

Signed-off-by: Leilk Liu <leilk.liu@xxxxxxxxxxxx>
---
drivers/spi/spi-mt65xx.c | 37 ++++++++++++++++++++-----------------
1 file changed, 20 insertions(+), 17 deletions(-)

diff --git a/drivers/spi/spi-mt65xx.c b/drivers/spi/spi-mt65xx.c
index 4fa4332..43c1dd5 100644
--- a/drivers/spi/spi-mt65xx.c
+++ b/drivers/spi/spi-mt65xx.c
@@ -48,15 +48,8 @@
#define SPI_CFG1_PACKET_LOOP_MASK 0xff00
#define SPI_CFG1_PACKET_LENGTH_MASK 0x3ff0000

-#define SPI_CMD_ACT_OFFSET 0
-#define SPI_CMD_RESUME_OFFSET 1
-#define SPI_CMD_CPHA_OFFSET 8
-#define SPI_CMD_CPOL_OFFSET 9
-#define SPI_CMD_TXMSBF_OFFSET 12
-#define SPI_CMD_RXMSBF_OFFSET 13
-#define SPI_CMD_RX_ENDIAN_OFFSET 14
-#define SPI_CMD_TX_ENDIAN_OFFSET 15
-
+#define SPI_CMD_ACT BIT(0)
+#define SPI_CMD_RESUME BIT(1)
#define SPI_CMD_RST BIT(2)
#define SPI_CMD_PAUSE_EN BIT(4)
#define SPI_CMD_DEASSERT BIT(5)
@@ -143,9 +136,14 @@ static void mtk_spi_config(struct mtk_spi *mdata,
reg_val = readl(mdata->base + SPI_CMD_REG);

/* set the mlsbx and mlsbtx */
- reg_val &= ~(SPI_CMD_TXMSBF | SPI_CMD_RXMSBF);
- reg_val |= (chip_config->tx_mlsb << SPI_CMD_TXMSBF_OFFSET);
- reg_val |= (chip_config->rx_mlsb << SPI_CMD_RXMSBF_OFFSET);
+ if (chip_config->tx_mlsb)
+ reg_val |= SPI_CMD_TXMSBF;
+ else
+ reg_val &= ~SPI_CMD_TXMSBF;
+ if (chip_config->rx_mlsb)
+ reg_val |= SPI_CMD_RXMSBF;
+ else
+ reg_val &= ~SPI_CMD_RXMSBF;

/* set the tx/rx endian */
#ifdef __LITTLE_ENDIAN
@@ -201,9 +199,14 @@ static int mtk_spi_prepare_message(struct spi_master *master,
cpol = spi->mode & SPI_CPOL ? 1 : 0;

reg_val = readl(mdata->base + SPI_CMD_REG);
- reg_val &= ~(SPI_CMD_CPHA | SPI_CMD_CPOL);
- reg_val |= (cpha << SPI_CMD_CPHA_OFFSET);
- reg_val |= (cpol << SPI_CMD_CPOL_OFFSET);
+ if (cpha)
+ reg_val |= SPI_CMD_CPHA;
+ else
+ reg_val &= ~SPI_CMD_CPHA;
+ if (cpol)
+ reg_val |= SPI_CMD_CPOL;
+ else
+ reg_val &= ~SPI_CMD_CPOL;
writel(reg_val, mdata->base + SPI_CMD_REG);

chip_config = spi->controller_data;
@@ -282,9 +285,9 @@ static void mtk_spi_enable_transfer(struct spi_master *master)

cmd = readl(mdata->base + SPI_CMD_REG);
if (mdata->state == MTK_SPI_IDLE)
- cmd |= 1 << SPI_CMD_ACT_OFFSET;
+ cmd |= SPI_CMD_ACT;
else
- cmd |= 1 << SPI_CMD_RESUME_OFFSET;
+ cmd |= SPI_CMD_RESUME;
writel(cmd, mdata->base + SPI_CMD_REG);
}

--
1.8.1.1.dirty

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/