[PATCH v2 4/4] spi: mediatek: revise coding style
From: Leilk Liu
Date: Thu Aug 20 2015 - 05:20:37 EST
This patch revises littery coding style according to comments.
Signed-off-by: Leilk Liu <leilk.liu@xxxxxxxxxxxx>
---
drivers/spi/spi-mt65xx.c | 52 ++++++++++++++++++++++++++++--------------------
1 file changed, 30 insertions(+), 22 deletions(-)
diff --git a/drivers/spi/spi-mt65xx.c b/drivers/spi/spi-mt65xx.c
index 43c1dd5..eaadc7e 100644
--- a/drivers/spi/spi-mt65xx.c
+++ b/drivers/spi/spi-mt65xx.c
@@ -16,6 +16,7 @@
#include <linux/device.h>
#include <linux/err.h>
#include <linux/interrupt.h>
+#include <linux/io.h>
#include <linux/ioport.h>
#include <linux/module.h>
#include <linux/of.h>
@@ -66,6 +67,8 @@
#define MT8173_SPI_MAX_PAD_SEL 3
+#define MTK_SPI_PAUSE_INT_STATUS 0x2
+
#define MTK_SPI_IDLE 0
#define MTK_SPI_PAUSED 1
@@ -178,7 +181,7 @@ static int mtk_spi_prepare_hardware(struct spi_master *master)
trans = list_first_entry(&msg->transfers, struct spi_transfer,
transfer_list);
- if (trans->cs_change == 0) {
+ if (!trans->cs_change) {
mdata->state = MTK_SPI_IDLE;
mtk_spi_reset(mdata);
}
@@ -235,8 +238,7 @@ static void mtk_spi_set_cs(struct spi_device *spi, bool enable)
static void mtk_spi_prepare_transfer(struct spi_master *master,
struct spi_transfer *xfer)
{
- u32 spi_clk_hz, div, high_time, low_time, holdtime,
- setuptime, cs_idletime, reg_val = 0;
+ u32 spi_clk_hz, div, sck_time, cs_time, reg_val = 0;
struct mtk_spi *mdata = spi_master_get_devdata(master);
spi_clk_hz = clk_get_rate(mdata->spi_clk);
@@ -245,21 +247,18 @@ static void mtk_spi_prepare_transfer(struct spi_master *master,
else
div = 1;
- high_time = (div + 1) / 2;
- low_time = (div + 1) / 2;
- holdtime = (div + 1) / 2 * 2;
- setuptime = (div + 1) / 2 * 2;
- cs_idletime = (div + 1) / 2 * 2;
+ sck_time = (div + 1) / 2;
+ cs_time = sck_time * 2;
- reg_val |= (((high_time - 1) & 0xff) << SPI_CFG0_SCK_HIGH_OFFSET);
- reg_val |= (((low_time - 1) & 0xff) << SPI_CFG0_SCK_LOW_OFFSET);
- reg_val |= (((holdtime - 1) & 0xff) << SPI_CFG0_CS_HOLD_OFFSET);
- reg_val |= (((setuptime - 1) & 0xff) << SPI_CFG0_CS_SETUP_OFFSET);
+ reg_val |= (((sck_time - 1) & 0xff) << SPI_CFG0_SCK_HIGH_OFFSET);
+ reg_val |= (((sck_time - 1) & 0xff) << SPI_CFG0_SCK_LOW_OFFSET);
+ reg_val |= (((cs_time - 1) & 0xff) << SPI_CFG0_CS_HOLD_OFFSET);
+ reg_val |= (((cs_time - 1) & 0xff) << SPI_CFG0_CS_SETUP_OFFSET);
writel(reg_val, mdata->base + SPI_CFG0_REG);
reg_val = readl(mdata->base + SPI_CFG1_REG);
reg_val &= ~SPI_CFG1_CS_IDLE_MASK;
- reg_val |= (((cs_idletime - 1) & 0xff) << SPI_CFG1_CS_IDLE_OFFSET);
+ reg_val |= (((cs_time - 1) & 0xff) << SPI_CFG1_CS_IDLE_OFFSET);
writel(reg_val, mdata->base + SPI_CFG1_REG);
}
@@ -268,11 +267,11 @@ static void mtk_spi_setup_packet(struct spi_master *master)
u32 packet_size, packet_loop, reg_val;
struct mtk_spi *mdata = spi_master_get_devdata(master);
- packet_size = min_t(unsigned, mdata->xfer_len, MTK_SPI_PACKET_SIZE);
+ packet_size = min_t(u32, mdata->xfer_len, MTK_SPI_PACKET_SIZE);
packet_loop = mdata->xfer_len / packet_size;
reg_val = readl(mdata->base + SPI_CFG1_REG);
- reg_val &= ~(SPI_CFG1_PACKET_LENGTH_MASK + SPI_CFG1_PACKET_LOOP_MASK);
+ reg_val &= ~(SPI_CFG1_PACKET_LENGTH_MASK | SPI_CFG1_PACKET_LOOP_MASK);
reg_val |= (packet_size - 1) << SPI_CFG1_PACKET_LENGTH_OFFSET;
reg_val |= (packet_loop - 1) << SPI_CFG1_PACKET_LOOP_OFFSET;
writel(reg_val, mdata->base + SPI_CFG1_REG);
@@ -280,7 +279,7 @@ static void mtk_spi_setup_packet(struct spi_master *master)
static void mtk_spi_enable_transfer(struct spi_master *master)
{
- int cmd;
+ u32 cmd;
struct mtk_spi *mdata = spi_master_get_devdata(master);
cmd = readl(mdata->base + SPI_CMD_REG);
@@ -291,9 +290,9 @@ static void mtk_spi_enable_transfer(struct spi_master *master)
writel(cmd, mdata->base + SPI_CMD_REG);
}
-static int mtk_spi_get_mult_delta(int xfer_len)
+static int mtk_spi_get_mult_delta(u32 xfer_len)
{
- int mult_delta;
+ u32 mult_delta;
if (xfer_len > MTK_SPI_PACKET_SIZE)
mult_delta = xfer_len % MTK_SPI_PACKET_SIZE;
@@ -434,7 +433,7 @@ static irqreturn_t mtk_spi_interrupt(int irq, void *dev_id)
struct spi_transfer *trans = mdata->cur_transfer;
reg_val = readl(mdata->base + SPI_STATUS0_REG);
- if (reg_val & 0x2)
+ if (reg_val & MTK_SPI_PAUSE_INT_STATUS)
mdata->state = MTK_SPI_PAUSED;
else
mdata->state = MTK_SPI_IDLE;
@@ -497,7 +496,7 @@ static int mtk_spi_probe(struct platform_device *pdev)
struct mtk_spi *mdata;
const struct of_device_id *of_id;
struct resource *res;
- int irq, ret;
+ int irq, ret;
master = spi_alloc_master(&pdev->dev, sizeof(*mdata));
if (!master) {
@@ -662,8 +661,10 @@ static int mtk_spi_resume(struct device *dev)
if (!pm_runtime_suspended(dev)) {
ret = clk_prepare_enable(mdata->spi_clk);
- if (ret < 0)
+ if (ret < 0) {
+ dev_err(dev, "failed to enable spi_clk (%d)\n", ret);
return ret;
+ }
}
ret = spi_master_resume(master);
@@ -689,8 +690,15 @@ static int mtk_spi_runtime_resume(struct device *dev)
{
struct spi_master *master = dev_get_drvdata(dev);
struct mtk_spi *mdata = spi_master_get_devdata(master);
+ int ret;
- return clk_prepare_enable(mdata->spi_clk);
+ ret = clk_prepare_enable(mdata->spi_clk);
+ if (ret < 0) {
+ dev_err(dev, "failed to enable spi_clk (%d)\n", ret);
+ return ret;
+ }
+
+ return 0;
}
#endif /* CONFIG_PM */
--
1.8.1.1.dirty
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/