Re: [PATCH] ARM: dts: use vqmmc-supply of emmc/sd for exynos4412-odroid-common

[Javier Martinez Canillas]

Hello Jaehoon,

On 08/27/2015 11:29 AM, Jaehoon Chung wrote:
> Currently vmmc's property is wrong.
> If it needs to control two supplies, then it has to use vmmc/vqmmc-supply.
> (Card supply power and I/O Line supply Power.)
> 
> Signed-off-by: Jaehoon Chung <jh80.chung@xxxxxxxxxxx>
> ---
>  arch/arm/boot/dts/exynos4412-odroid-common.dtsi | 7 ++++---
>  1 file changed, 4 insertions(+), 3 deletions(-)
> 
> diff --git a/arch/arm/boot/dts/exynos4412-odroid-common.dtsi b/arch/arm/boot/dts/exynos4412-odroid-common.dtsi
> index ca7d168..4ddabfd 100644
> --- a/arch/arm/boot/dts/exynos4412-odroid-common.dtsi
> +++ b/arch/arm/boot/dts/exynos4412-odroid-common.dtsi
> @@ -461,10 +461,10 @@
>  &mshc_0 {
>  	pinctrl-0 = <&sd4_clk &sd4_cmd &sd4_bus4 &sd4_bus8>;
>  	pinctrl-names = "default";
> -	vmmc-supply = <&ldo20_reg &buck8_reg>;
> +	vmmc-supply = <&ldo20_reg>;
> +	vqmmc-supply = <&buck8_reg>;
>  	mmc-pwrseq = <&emmc_pwrseq>;
>  	status = "okay";
> -
>  	num-slots = <1>;
>  	broken-cd;
>  	card-detect-delay = <200>;
> @@ -485,7 +485,8 @@
>  	bus-width = <4>;
>  	pinctrl-0 = <&sd2_clk &sd2_cmd &sd2_cd &sd2_bus4>;
>  	pinctrl-names = "default";
> -	vmmc-supply = <&ldo4_reg &ldo21_reg>;
> +	vmmc-supply = <&ldo21_reg>;
> +	vqmmc-supply = <&ldo4_reg>;
>  	cd-gpios = <&gpk2 2 0>;
>  	cd-inverted;
>  	status = "okay";
>

I didn't check against the board schematics
but the change makes sense to me.

Reviewed-by: Javier Martinez Canillas <javier@xxxxxxxxxxxxxxx>
 
Best regards,
-- 
Javier Martinez Canillas
Open Source Group
Samsung Research America
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/