[PATCH v4 11/13] tty: serial: 8250: Remove SERIAL_DEBUG_PNP macro

[Anton Wuerfel]

From: Phillip Raffeck <phillip.raffeck@xxxxxx>

This patch removes the macro SERIAL_DEBUG_PNP, which is used to enable
debugging at compile time.
As SERIAL_DEBUG_PNP is an orphan, the corresponding #ifdef is removed.
To keep the ability to enable debugging at compile time,
the call to printk(KERN_DEBUG ...) is replaced by a corresponding
call to dev_dbg(), which is configurable via CONFIG_DYNAMIC_DEBUG.

Signed-off-by: Phillip Raffeck <phillip.raffeck@xxxxxx>
Signed-off-by: Anton WÃrfel <anton.wuerfel@xxxxxx>
CC: linux-kernel@xxxxxxxxxxxx
---
 drivers/tty/serial/8250/8250_pnp.c | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/drivers/tty/serial/8250/8250_pnp.c b/drivers/tty/serial/8250/8250_pnp.c
index ffa7354..ba3a1af 100644
--- a/drivers/tty/serial/8250/8250_pnp.c
+++ b/drivers/tty/serial/8250/8250_pnp.c
@@ -464,11 +464,11 @@ serial_pnp_probe(struct pnp_dev *dev, const struct pnp_device_id *dev_id)
 	} else
 		return -ENODEV;
 
-#ifdef SERIAL_DEBUG_PNP
-	printk(KERN_DEBUG
-		"Setup PNP port: port %x, mem 0x%lx, irq %d, type %d\n",
-		       uart.port.iobase, uart.port.mapbase, uart.port.irq, uart.port.iotype);
-#endif
+	dev_dbg(&dev->dev,
+		 "Setup PNP port: port %x, mem 0x%lx, irq %d, type %d\n",
+		 uart.port.iobase, uart.port.mapbase,
+		 uart.port.irq, uart.port.iotype);
+
 	if (flags & CIR_PORT) {
 		uart.port.flags |= UPF_FIXED_PORT | UPF_FIXED_TYPE;
 		uart.port.type = PORT_8250_CIR;
-- 
1.9.1